Repair Manual

10
10 - 55
ENGINE AND LOWER ENGINE UNITS
Disconnect the battery.
Place the no.1 cylinder at the dead point in
orde to avoid the falling of the key from the
crankshaft when disounting the crankshaft pul-
ley.
Dismount :
- engine shield;
- alternator belt;
- crankshaft pulley.
Dismount the old annular oil seal by means of
the MOT 457 A device.
REPLACEMENT OF THE DISTRIBUTION ANNULAR OIL SEAL
D
ISMO UNTING
Mount the new annular oil seal on the mount-
ing chuck of the MOT 457 A device.
Lubricate the outside of the annular oil seal
with oil and place it on the cap.
Tighten the nut until the chuck comes into
contact w ith the cap.
Mount:
- the crankshaft pulley after the
surface between the pulley hub and the
distributtion pinion has been lubricated with
LOCTITE 518
.
Mount the alternator belt and adjust its
tightness.
R
EMOUNTING
vnx.su