Repair Manual

10
10 - 57
ENGINE AND LOWER ENGINE UNITS
REMOUNTING
Mount the distribution annular oil seal.
Place the cap with new gasket or on the block after sealant material has been applied previously.
Center the cap by means of the MOT 457 A device.
Attach the cap on the block; the tightenin of the screws is done from the upper part towards
the lower part.
Re mount the crankshaft pulley,the water pump pulley, the alternator belt.
Place:
- the rubber gaskets of the bearings;
- the side gaskets of the oil sump.
In case sealant material is used , this is to be applied as per bellow described procedure.
Mount the oil sump taking care not to displacethe gaskets ot the sealant material.
Tighten the attachment screws from the center towards the edges.
Re mount the engine shield.
Perform the filling with oil of the engine.
For engines fitted after 01.06.1999 the sealaing of the distribution cap is done with sealant
material ( instead of the distribution cap gasket ),the necessary quantity of sealant material is 15
grams.
Any dismounting of the distribution cap nrequires the replacing of the sealant material layer.
Proceed as follows:
Remove the old sealant material by scrapping with a knife from the contact surface of the
distribution cap and engine casing.
DISTRIBUTION CAP
vnx.su