Repair Manual

10
10 - 58
ENGINE AND LOWER ENGINE UNITS
Clean with 002 solvent the contact surfaces of the engine casing and of the distribution cap .
Place a continous sealant material layer of a 3 mm thickness on the lower part of the contact
surface of the distribution cap,taking care not to obturate the its fixing holes.
Mount the distribution cap and tighten the attachemnt screws at the required moment.
ATTENTION !
Mounting of the distribution cap on engine casing must be done in maximum
5 minutes from the sealant material application.
At the distribution cap which is mounted with sealant material, the drawings of the
contact surface are towards the exterior ( see chapter
A - A ) different from the ones
mounted with gaskets where the drawings are towards the interior.
The distribution cap mounted with sealant material can not be mounted with gaskets
and the ones mounted with gasketes can not be mounted with sealant material.
DISTRIBUTION CAP
vnx.su