Repair Manual

10
10 - 63
ENGINE AND LOWER ENGINE UNITS
Mount the control pinion of the breaker distributor.
The control pinion is positioned as follows:
- place the no.1 cylinder at the upper dead point, on ignition;
- mount the pinion with a cylinder head attachement screw so that the slots are
perpendicular on the engine longitudinal axle and the larger part (D) is oriented towards the
flywheel.
Re mount the pushers lubricated with fresh oil,the cylinder head ,the tilters shafts.
Adjust the tilters ( thermal clearance ) at cold :
- inlet - 0,15 mm;
- outlet - 0,20 mm.
Mount the tilters c ap.
Mount the fuel pump,the breaker-distributor.
Re mount the radiator ,the front grill ,the air filter.
Mount the alternator belt and adjust its tightening.
Perform: oil filling of the engine,filling and aeration of the cooling system,engine
checking and adjustement ( ignition,carburation ).
CAMSHAFT
vnx.su