Repair Manual

10
10 - 65
ENGINE AND LOWER ENGINE UNITS
The quantity of sealant material necessary for one engine is max. 60 grams, of which max. 15
grams for the distribution cap and max. 45 grams for oil sump.
Proceed as follows:
Remove trhe oil sump.
Remove the old sealant material using a knife by scrapping , from the contact surface a of oil
sump and enine casing.
Clean with 002 solvent the contact surfaces of the engine casing and the oil sump.
Place a continous layer of sealant material of a 3 mm thickness on the interior part of the oil
sump contact surface taking care not to obturate its fixing holes.
Mount the oil sump and tighten the attachement screws at the required moment.
ATTENTION !
The oil sump mounting on engine casing must be done in maximum 5 minutes from
sealuing matterial application.
For the oil sump which is sealed with sealant material,the drawings of the contact
surface are towards the exterior, different from the ones mounted with gaskets where
the drawings are towards the interior.
The oil sump mounted with sealant material can not be mounted with gaskets and
the ones mounted with gasketes can not be mounted with sealant material.
LOWER CRANKCASE
vnx.su