Installation Instructions

Microwave Trim Kit Instructions
Page 4
STEP 8 Hold the remaining trim support in the mounting position on the top edge of
the cutout and center it left to right. IMPORTANT: Use a measuring tape or
ruler to center the piece in the cutout. If the trim support is not centered, the
trim assembly will not t properly.
STEP 9 While holding the trim support in place, using a pencil, mark 4 pilot hole loca-
tions in the underside of the top of the cabinet cutout.
STEP 10 Drill 4 pilot holes for the top trim support using a 3/32” drill bit.
STEP 11 Attach the top trim support to the top front of the cabinet using (4) #10 x 1/2
Phillips head screws.