Installation Instructions Warming Drawer Pr el im in ar y -F or Re vi ew O nl y Models: DWD30, ERWD27, ERWD30, EWD24, EWD27, EWD30, EWD36, IWD24, IWD27, IWD30, MRWD27, MRWD30, MWDH27, MWDH30, MWDV27, MWDV30, OWD24, RWDV30 Part No. 102345 Rev.
All specifications are subject to change without notice. Dacor ® assumes no liability for changes to specifications. © 2007 Dacor, all rights reserved.
Table of Contents Before You Begin............................................................... 1 Important Safety Instructions........................................... 1 General Safety Precautions.............................................. 2 Installation Specifications................................................. 3 Verifying the Package Contents........................................ 3 Installation Planning..........................................................
Important Safety Instructions General Safety Precautions To reduce risk of fire, electric shock, serious injury or death when using your appliance, follow basic precautions, including the following: warning • Use this appliance only for its intended use as described in this manual. Use it only to warm food and heat plates and utensils. It is not designed for commercial, industrial or laboratory use. • Only model OWD24 is approved for use in outdoor installations and near water (bathrooms).
Installation Specifications Verifying the Package Contents • (3) mounting screws - PN 83569 • Wire rack with mounting hardware (OWD24 only) (1) PN 83619 (screw), (1) PN 83267 (clamp) C B Installation Planning • A qualified technician must complete the installation of this builtin appliance. Proper installation is the customer's responsibility. • Carefully check the location where the drawer is to be installed. The drawer should be placed for convenient access.
Installation Specifications (A) Drawer Face Width (B) Chassis Face Width (C) Chassis Width DWD30 30” (76.2 cm) 29 5/8” (75.2 cm) 28 1/4” (71.8 cm) ERWD27 27” (68.6 cm) 26 5/8” (67.6 cm) 25 1/4” (64.1 cm) ERWD30 30” (76.2 cm) 29 5/8” (75.2 cm) 28 1/4” (71.8 cm) EWD24 24” (61.0 cm) 23 5/8” (60.0 cm) 22 1/4” (56.5 cm) EWD27 27” (68.6 cm) 26 5/8” (67.6 cm) 25 1/4” (64.1 cm) EWD30 30” (76.2 cm) 29 5/8” (75.2 cm) 28 1/4” (71.8 cm) EWD36 36” (91.4 cm) 35 5/8” (90.5 cm) 34 1/4” (87.
Installation Specifications Warming drawer 36" typ. (91.4 cm) C A B D Warming drawer D 120 Vac electrical outlet Warming drawer 3/4" min.* (1.9 cm) 27"/30"/36" Dacor single wall oven C 3/4" min.* (1.9 cm) Warming drawer Warming drawer 36" typ. (91.4 cm) A B C 120 Vac elect. Toe kick 120 Vac electrical outlet Cutouts Dimensions NOTES: • Models EWD36 and OWD24 cannot be installed above or below another warming drawer (any type).
Installation Specifications Install Support Platform in Cabinet Chassis face Provide a platform (100 lb. load capacity) within the cabinet upon which the warming drawer will be supported. The platform must be installed level and straight. The top edge of the platform must be flush with the cutout at the front of the cabinet. There are no provisions to level the warming drawer after it has been installed. 3/4” (1.9 cm) thick plywood is recommended.
Installation Instructions warning • T o avoid personal injury caused by the appliance falling forward when the drawer is opened, secure the chassis to the cabinet and support platform as instructed. • Be certain that the power plug is disconnected from the electrical outlet before installation. • Verify that the electrical supply matches the ratings found on the appliance data plate and the installation specifications before proceeding.
Installation Instructions Re-installing the Drawer Towel Rack Installation 1. Pull the drawer slides all the way out of the drawer opening. (OWD24 Only) 2. Gently lower the drawer between the extended slides until it is suspended by them. 3. Slide the back of the drawer mounting brackets under the drawer mounting clips on the slides. Model OWD24 is designed so that it can be used as a towel warmer if desired. Other models are not equipped for this application.
Installation Instructions Warming Drawer Control Panel Layout Verify Warming Drawer Operation 1. Connect power plug to the electrical outlet. 2. Open the drawer and press the ON/OFF key on the control panel. 3. Press the PROOF, LOW, MED and HIGH keys each in turn. When you press each key, the indicator directly above it should light. Leave the control panel set to HIGH.
Dacor ● 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.