I n s ta l l at i o n I n s t r u c t i o n s M i c r o wav e I n -A-D r aw e r ™ For use with models: MMDV30S MMD30S MMD30B Part No. 101589 Rev.
Table of Appliance Safety...........................................................................1 Installation Recommendations....................................................1 Important Notes To The Installer.................................................1 Important Notes To The Consumer.............................................1 Important Safety Instructions......................................................2 Grounding Instructions..........................................................
Important Safety Instructions WARNINGS If the information in this manual is not followed exactly, a fire or electrical shock may result that could cause property damage, personal injury or death. To reduce the risk of tipping, the Microwave In-A-Drawer™ must be secured by a properly installed Anti-Tip block. • This drawer must be electrically grounded in accordance with local codes. • Make sure the wall coverings and the cabinets around the drawer can withstand the heat generated by the microwave.
Design Specifications J M N DRAWER MEASUREMENTS A B C F G I S A. 84" wall cabinet B. Optional wall oven cutout illu sketch C. Electrical outlet location D. 6" E. Anti-Tip block F. 3 1/2" G. 5" H. 4" I. 2" minimum D H Figure 1 E A. 28 1/8" B. 4 11/16" C. 2" D. 23 3/8" E. 30" F. 15 5/8" G. 15 1/16" H. 1 1/4" door thickness I. 13 5/8" auto drawer opening Figure 3 Figure 2 CLEARANCES AND DIMENSIONS • Dimensions that are shown in Figures 2 and 3 must be used.
Design Specifications ANTI-TIP BLOCK Normal Installation Steps Anti-Tip BLOCK Installation Instructions To reduce the risk of tipping of the drawer, the Anti-Tip block must be properly installed located 14 3/4" above the floor on which the Microwave In-A-Drawer™ will sit. The 6" Anti-Tip block must be provided by the installer. See Figures 2, 3 and 4. The Anti-Tip block prevents serious injury that might result from spilled hot liquids.
Installation Instructions VERIFYING PACKAGE CONTENTS DRAWER INSTALLATION • Remove all packing materials from inside the drawer. DO NOT REMOVE THE WAVEGUIDE COVER, which is located on the top of the Microwave In-A-Drawer™. • Remove the feature sticker, if there is one. Check the drawer for any damage, such as misaligned or bent drawer, damaged drawer seals and sealing surfaces, broken or loose drawer guides and dents inside the cavity or on the front side of the drawer.
Specifications contained within are subject to change without notice. No liability is assumed by DACOR® for changes in specifications. The information and images in this book are the copyright property of Distinctive Appliances, Inc. Neither this book nor any information or images contained herein may be copied or used in whole or in part without the express written permission of Distinctive Appliances, Inc. Web Site: Phone: www.Dacor.com (800) 793-0093 © 2006 Distinctive Appliances, Inc.
