Installation Instructions Renaissance Wall Oven Models: EOR, MOR Part No. 102579 Rev.
All specifications are subject to change without notice. Dacor ® assumes no liability for changes to specifications. © 2007 Dacor, all rights reserved.
Table of Contents Before You Begin............................................................... 1 Important Safety Instructions........................................... 1 Important Information About Safety Instructions............... 1 Safety Symbols and Labels.............................................. 1 General Safety Precautions.............................................. 2 Customer Service Information.......................................... 3 If You Need Help..................................
Important Safety Instructions General Safety Precautions To reduce the risk of fire, electric shock, serious injury or death when using your appliance, follow basic safety precautions, including the following: WARNING 1. Read the accompanying use and care manual before operating this appliance. 2. Keep packaging materials away from children. Plastic sheets and bags can cause suffocation. 3. If you receive a damaged product, immediately contact your dealer or builder.
Customer Service Information If You Need Help... Model Identification • If you have questions or problems with installation, contact your Dacor dealer or the Dacor Customer Service Team. When you call, have the model and serial number of the appliance ready. The model and serial number are printed on the appliance data plate. Dacor Customer Service Team Phone: (800) 793-0093 E-mail: customerservice@Dacor.com Web site: www.Dacor.
Product Specifications Power Supply Requirements • It is the owner’s responsibility to ensure that a licensed electrician performs the installation of the electrical supply for this appliance. The electrical installation, including minimum supply wire size, must comply with the National Electric Code ANSI/NFPA 70 (latest revision) and local codes and ordinances.
Design Specifications Product Dimensions All tolerances: +1/16 (1.6 mm). -0, unless otherwise stated. Top of Chassis B* L J L B* J F Top of Chassis F G G H C H D Light Cover C D A Conduit: 60” (152 cm) Long K Control Panel Front E M Chassis Notch Side View Top of Chassis * Width at light covers on both sides Single Oven Control Panel Front 1” (2.5 cm) 1” (2.5 cm) Chassis Notch Side View A K E M Light Covers Conduit: 60” (152 cm) Long Top of Chassis Double Oven 3 3/8” (8.
Installation Specifications Installation Planning • Dacor recommends installing the electrical junction box in the one of the locations shown. • Install the junction box in a location that allows the oven to be removed from the the cut out for service without being disconnected. warning Observe all governing codes and ordinances during planning and installation. Contact your local building department for further information. • Plan the installation so that all minimum clearances are met or exceeded.
Installation Specifications Cabinet Dimensions N N Recommended Electrical Location 1” (2.5 cm) min. to bottom of cabinet door 1” (2.5 cm) min. to bottom of cabinet door R 3/4” (1.9 cm) Support Platform R P P 1” (2.5 cm) min. to top of cabinet door Recommended Electrical Location Alternate Electrical Location 1” (2.5 cm) min. to top of drawer face 3/4” (1.9 cm) Support Platform 31 1/4” (79.
Installation Instructions Verify the Package Contents Verify that all the components below have been provided. If any item is missing or damaged, please contact your dealer immediately. Do not install a damaged or incomplete appliance. Make sure that you have everything necessary to ensure proper installation before proceeding.
angle to remove. Installation Instructions Removing the Oven Door on Model EORS136: 1. Open the door to its fully opened position. 2. Rotate the catch over the retaining arm on each hinge. Catch 3. Lift the oven door to about a 15° angle from the vertical position. 4. Hold the door with both hands just below the handle and pull it away from the oven while continuing to lift.
Installation Instructions Electrical Connection - (continued) Connecting to a Four Wire Electrical System Connecting to a Three Wire Electrical System - Where Local Codes Permit 1. Separate the wires coming out of the appliance conduit. 2. Connect the white wire from the appliance conduit to the white (neutral) supply wire in the junction box. 3. Connect the black wire from the appliance conduit to the black (L1) supply wire in the junction box. 4.
Installation Instructions Connecting to a Three Wire Electrical System with External Ground - Where Local Codes Permit 4 AWG wire (minimum) Insulating device warning • Do not ground the appliance to a gas supply pipe or hot water pipe. • If connecting the ground wire to a grounded cold water pipe, connect using a separate copper grounding wire (No. 10 minimum) and a clamp with an external grounding screw.
Installation Instructions Installing the Oven in the Cabinet warning • Failure to properly install the mounting screws may result in movement or tipping of the oven during use resulting in personal injury. • Do not block the oven air exhaust located at the bottom of the oven. Blocking the intake may result in a fire hazard, cabinet damage or poor performance. 3. Locate the mounting holes in the trim on both sides of the oven.
Installation Instructions Installing the Exhaust Grill With the oven secured to the cabinet, install the exhaust grill by mounting it to the oven with the two (2) provided screws. Reinstalling the Oven Doors warning Failure to fully rotate the hinge catches will result in a safety hazard and may cause personal injury due to the door falling off its hinges. Also damage to the oven and/or improper door alignment may occur.
Installation Instructions Reinstalling the Oven Door (Cont) Verifying Proper Operation To re-install the oven door on model EORS136: warning 1. For stainless steel ovens, peel off the protective layer of plastic that covers the stainless steel surfaces. 2. Remove any packaging from inside the oven(s). To avoid personal injury or damage to the door from it falling off its hinges: 3. Slide the oven racks onto the supports inside the oven chamber(s) according to the use and care manual.
Installation Instructions Installation Checklist warning To ensure proper installation, the installer must complete the checklist below to make sure that no part of the installation has been overlooked. □□Is the oven mount on a level platform? □□Is the oven wired and grounded according to these instructions and in accordance with all applicable electrical codes? (See Pages 4 and 9-11.
Notes 16
Dacor ● 1440 Bridge Gate Drive, Diamond Bar, CA 91765 ● Tel: (800) 793-0093 ● FAX: (626) 403-3130 ● www.Dacor.