Installation Instructions Distinctive ® Series Cooktop Models DCT305, DCT365 Part No. 106927 Rev.
Table of Contents Important Safety Instructions........................................... 1 Important Information About Safety Instructions............... 1 General Safety Precautions.............................................. 2 Installation Specifications................................................. 3 Product Dimensions.......................................................... 3 Electrical Requirements.................................................... 4 Gas Supply Requirements....................
Important Safety Instructions Important Information About Safety Instructions • The Important Safety Instructions and warnings in these instructions are not meant to cover all possible problems and conditions that can occur. Use common sense and caution when installing, maintaining or operating this or any other appliance. • Always contact the Dacor Customer Service Team about problems and conditions that you don’t understand. See Customer Service Information.
Important Safety Instructions General Safety Precautions To reduce the risk of fire, electric shock, serious injury or death when using this appliance, follow basic safety precautions, including the following: WARNING • Read the accompanying use and care manual completely before operating this appliance. • Keep packaging materials away from children. Plastic sheets and bags can cause suffocation. • If you receive a damaged product, immediately contact your dealer or builder.
Installation Specifications WARNING Observe all governing codes and ordinances during planning and installation. Contact your local building department for further information. Product Specifications All tolerances ±1/16” (±1.6 mm) unless otherwise noted. A 2" (5.1 cm) countertop to cooking surface 4" (10.2 cm) chassis height Model (A) (B) DCT305 30” (76.2 cm) 27 5/16” (69.4 cm) DCT365 36” (91.4 cm) 33 5/16” (84.6 cm) Rear overhang 1 3/16” (3.0 cm) Front overhang 17/32” (1.3 cm) 21" (53.
Installation Specifications Electrical Requirements WARNING To prevent an electric shock hazard, the power supply must meet the specifications stated below. It is the owner’s responsibility to make sure that the electrical service meets electrical requirements and that the electrical outlet has been properly installed by a licensed electrician. • • The cooktop is supplied with a factory installed, 42 inch long, power cord with a three-prong, grounding electrical plug.
Installation Specifications Cabinet and Countertop Layout • WARNING • Failure to meet or exceed the maximum and minimum dimensions/clearances stated in these instructions may result in a fire hazard. • Follow the countertop manufacturer’s instructions regarding the minimum corner radius, use of heat reflective tape, reinforcement of corners, etc. • • B Carefully check the location where the cooktop will be installed.
Installation Specifications Cutout Dimensions All tolerances +1/16” -0 (+1.6 mm, 0) unless otherwise noted. Rear wall Vertical combustible surface 4 1/4” (10.8 cm) min. from mounting surface to combustibles below cooktop chassis C F E D F Minimum distance to combustible side wall above countertop (both sides) 1 5/8” min. (4.
Installation Instructions Verify Package Contents Connecting the Gas Line • Hold down brackets (2) • Grates (3) • Burner sets (5) • Gas pressure regulator with 3/4” to 1/2” reducer • Stainless steel cleaner WARNING Installing the Cooktop WARNING • Verify that the power supply meets the specifications on page 4 before proceeding. • To prevent damage to the gas pressure regulator, install it only after the cooktop is mounted in its permanent position.
Installation Instructions Installing the Burner Components WARNING • Never attempt to operate the cooktop with any of the burner parts removed. • Do not attempt to adjust the burner air mixture settings. All adjustments are preset at the factory. 1. Remove the burner rings, burner caps and grates from their shipping packages. 2. Assemble the burners as shown. Match the burner parts to the correct size and type of burner. When installing the burner components, make sure they are centered.
Installation Instructions IMPORTANT: Install the grates as instructed below for longest life. When installed properly, the openings in the grates are centered over the burners. 3. Locate the notch on the bottom of each grate. 4. Use the notch on the bottom of each grate to determine location and orientation. See diagram below. The notch on the bottom of each grate goes towards the back of the cooktop. The notches on the left and right grates go toward the outside. 5.
Installation Instructions Verifying Proper Operation WARNING • • Make sure that power to the electrical outlet is turned off at the circuit breaker panel or fuse box and that the gas is turned off at the gas supply valve before proceeding. The cooktop must be properly grounded at all times when electrical power is applied. Prior to operating the cooktop, read the accompanying use and care manual carefully. 1.
Installation Instructions Installation Checklist WARNING • To ensure a safe and proper installation, the following checklist should be completed by the installer to ensure that no part of the installation has been overlooked. • Proper installation is the responsibility of the homeowner. The importance of proper installation of your Dacor cooktop cannot be overemphasized.
Wiring Diagram WARNING Label all wires prior to dis-connection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing 120 Vac, 60 Hz.
Dacor ● 14425 Clark Avenue, City of Industry, CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.