cdacor ee Se Installation Distinctive’ Instructions Electric Cooktop 105643 Rev.
ENGLISH Table of Contents Special Warnings .............: eerie / Page A 3 e Product Dimensions and Cutout Requirements............. 4 Important Preparation SuggestiOns..........00..c:cceeeeeeeee eee 5 Cooktop Installation... eee eerie 6 Electrical CONNECTIONS... nee General infOrimauion eee — S-Wire branch CHCUIE ee 9 e L WARNING This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others.
ENGLISH <— “a : no a 8 ; NN oN DECT304 00 oe TC > N DECT365 S N Se ee ee . _ Figure 1. Chassis dimensions CUTOUT DIMENSIONS WIDTH OF CUT DEPTH OF CUT B SEE NOTE 4-1/2" (3.8 cm) MIN CLEARANCE R FROM EDGE OF CUTOUT Hole in cabinet AND FRONT EDGE OF floor for conduit COUNTERTOP routing: 1" (2,5em) 3 1/2" (9 cm) deep x 2 1/2” (6.
ENGLISH CABINET REQUIREMENTS WALL COVERING CABINETS, AND COUNTERTOP MUST WITHSTAND HEAT UP TO 200°F (93°C) INST 023-2 Figure 3. Cabinet dimensions and requirements CUTOUT WIDTH A 28-11/16” 30” " (76.2cm) Cc D 19-9/16 (49.7 om) 49-1/4" . 19-9/16 (49.7 cm) 18” » (45.7 cm) (76.2 cm) min | yin height from countertop to nearest cabinet » on either side (86,5 cm) to | (49.0 cm) to | 36 34-5/16 (87.2 cm) E F G 19-1/4” (72.9 cm) ; to | (49.0 cm). to | 30” 28 15/16 (73.
ENGLISH A Step 1 Remove packaging materials and literature package from the cooktop before beginning installation. Remove installation manual from literature pack and read them carefully before you begin. WARNING e Excessive Weight Hazard Use two or more people to move and install cooktop. Failure to do so can result in back or other injury. e Cut Hazard Beware of sharp edges. Use the polystyrene ends when carrying the product. Failure to use caution \ could result in minor injury or cuts.
cms Step 2 Place a towel or table cloth onto the counter top. Lay the cooktop upside down onto the protected surface. BURNER BOX TABLE CLOTH Figure 8 Figure 6 Step 3 A foam tape is provided to seal the cooktop edges to the countertop. Apply tape approximately 1/16" (1.5 mm) from the glass edge to the underside of the cooktop glass. Use tape around the entire glass perimeter. Cut off excess where tape ends buit. Step 5 Four clamp brackets are provided to clamp the cooktop to the countertop.
ENGLISH CONDUIT OPENING LOCATIONS OF ALUMINUM > 12" (30.5 cm) MIN FROM BOTTOM OF COUNTERTOP AND ADJACENT CABINET (RIGHT SIDE) REFLECTIVE TAPE —— I i _| A TAPE TOP AND VERTICAL SIDES OF CUTOUT INSTALL JUNCTION BOX SO THAT IT CAN BE REACHED TROUGH THE t.
> ENGLISH DANGER Disconnect power before servicing the product. Failure to do so could result in death or electrical shock. General information A The flexible conduit (supplied) 4 feet long (123 cm) located at the right rear of the cooktop bottom box should be connected directly to junction box. Do not cut or lengthen the conduit. A ULL - or CSA - listed conduit connector must be provided at each end of the power supply cable (at the cooktop and at the junction box.
ENGLISH Recommended 3-WIRE CABLE FROM POWER SUPPLY Minimum kW Rating on Circuit protection Wire size serial plate in amperes (AWG) 0-4.8 20 12 4.9-6.9 30 10 7.0-9.9 40 8 10.0-114.9 50 8 12.0-14.9 60 6 Be sure your appliance is properly installed and grounded by a qualified technician. Ask your dealer to recommend a qualified technician or an authorized repair service. This cooktop does not require a neutral connection.
ed 11-11 Cod. 09DR5800 cacor The Life of the Kitchen? Dacor e 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 « Phone: (800) 793-0093 e Fax: (626) 403-3130 « www.dacor.
