Installation Manual

26 English
Installation Instructions
Inserting Light Bulbs
Use only dimmable bulbs. Using non-dimmable bulbs causes damage and faulty operation. If needed,
clean the lens surface so the suction cup will stick to it. Perform this procedure for each hood light.
Fixture
Dimmable
B
ulb
Suction
Cup
1. (To avoid a possible short and significant property
damage) Shut the main circuit breaker OFF.
2. Attach the suction cup to the bulb lens (both
supplied; see the graphic).
3. Screw the bulb into the light fixture, and remove
the suction cup.
4. Switch the main circuit power ON.
Replacement Part # Description
702666
Dimmable LED Bulb Replacement Kit
(1 bulb + 1 suction-cup tool)
Verifying Proper Function
ONOFF
1. Turn OFF the main power switch.
2. Turn power ON at the circuit-breaker panel or
fusebox.
3. Turn ON the main power switch. (The button
panel flashes several times during startup.)
4. (Without scratching the grease channel or other
surfaces) Insert the filters:
a. Set the front edge against the clip, and press.
b. Lift the rear edge above the grease channel.
c. Set the filter rear edge on the grease channel.
5. On the control panel, press Lights to verify that
all lights turn on.
6. Press Lights to turn the lights to Low, then press
again to turn the lights off.
7. Press POWER to verify that one fan-speed
indicator turns on and the fan is on Low.
8. Press Low/Med/High/Boost to verify that the fan
speed increases each time.
9. Press POWER to turn the fan OFF.
Main Power
Switch Detail/
Hood Bottom
Filter
Main Power
Switch
Grease
Channel
Filter
Back
Bottom
Front Filter
Clip
Grease
Channel
Lights
If the Hood Fails to Function Correctly
1. Verify that the hood receives power.
2. Remove the right-most filter to access the main power switch, and confirm the hood is ON.
3. Verify that the electrical connections are correct.
4. Re-run Verifying the Setup.
If the hood still does not work, contact Dacor Customer Assurance (see Pg. 3). Do not make your
own repairs. Dacor will will not pay for serv
ice needed to correct unauthorized repairs.