Installation Instructions

23
Installation
Attach Dacor badge
Use the template on this page for alignment of the badge.
Cut out the template and tape it onto the hood front
surace and verify the template is aligned with the right
side of the hood and within the upper and lower edge of
the front surface. Practice placing the badge rst before
removing the adhesive release paper.
Template
Bott
om edge of
the duct cover
Duct cover
NOTE: The nameplate badge has very high retention adhesive - once the nameplate badge is attached its extremely difficult to remove.
Before removing the release paper from the back of the nameplate badge, practice placing the nameplate badge in the proper position on the hood
without any overlap between the nameplate badge and this template.
After this practice, remove the release pper from the back of the nameplate badge, and attach the nameplate badge to the hood without any overlap
of the nameplate badge to this template.
Remove and discard this template.
Dacor
Badge