Installation Guide
24
Installation
Installing the Anti-Tip Block
This block keeps the oven from tipping forward
and possibly spilling hot foods and liquids.
It must be installed so its bottom is 14 13/16”
above the cutout oor.
The installer shall provide the anti-tip block.
(See pgs. 9 and 10 for specic placements.)
If the drawer is relocated, relocate the block
with it.
Installing the Microwave In-A-Drawer
™
1. Place the drawer in front of its cutout.
2. Plug in the power cord, and slide the unit
into the cutout until the mounting ange
meets the cabinet face. (Do not pinch the
cord between the chassis and the wall.)
3. On the control panel, press Open. The draw-
er opens, exposing the four anchor-screw
holes. (See the graphic at left.)
4. Using the 4 holes as a template, predrill
the cabinet with a 1/16” bit, then anchor the
drawer with the 4 provided screws.
About the Electrical Outlet
A 120 volt 60 Hz, AC only, 15 amp. or more pro-
tected electrical supply is required. It is prefer-
able that the oven be on its own circuit.
The drawer has a 3-prong grounding plug that
must be plugged into a properly installed and
grounded outlet. If only a 2-prong outlet is
available, have a qualied electrician install a
proper outlet.
NOTE: Address any questions to a qualied
electrician or service technician.