Users Manual

English 77
Care and maintenance
4. Open the door fully. If it does not lie
perpendicular to the oven, remove the
door, and repeat Steps 1 – 3.
5. At each hinge of the oven door, flip the
hinge locks up into the locked position.
(See Removing the oven doors, Step 3,
graphic A, pg. 75.)
6. Close the oven door.
There should be an even gap between
the door and control panel. If one side
has a wider gap, the hinge on that side
is improperly installed.
7. Reconnect the LED wire harness.
CAUTION
Push the wiring inward as it was before you removed the door. Dangling wiring may
snag on the door or become heat-damaged.