installation

27English
Installation Instructions
About Oven Functions, cont.
Before sliding the range into the cabinet
1. Turn off the gas-supply valve, and turn off power to the
range.
2. 
on the stub out. The line must be long enough that the
range can be pulled out for service without disconnect-
ing the line.
3. Slide the gas line up through the chassis' access holes to
the regulator. (Move the wires inside the access holes to
keep them from catching on the gas line.)
4. Connect the gas line to the regulator.
5. Turn off all cooktop controls, then turn on the gas supply.
6. With a soap-and-water solution, check all lines and con-
nections for leaks.
7. Turn off the gas-supply valve.
Final Installation
Gas Connection, cont.
1. Peel the protective sheeting from the range.
2. 
legs as needed to position the trim around the cooktop
even with or above the countertop.
3. Turn to lower the anti-tip foot at the back of the range

4. Slide the range into the cutout so the anti-tip foot en-

5. With a level, check that the range does not tilt in any
direction. (Adjust the legs to level the range as needed.)