Installation Instructions
Table Of Contents
- Before you begin
- Customer service information
- Important safety instructions
- Product specifications
- Installation requirements
- Installation instructions
- Antes de comenzar
- Información del servicio al cliente
- Instrucciones de seguridad importantes
- Especificaciones del producto
- Requisitos de instalación
- Instrucciones de instalación
- Avant de commencer
- Informations relatives au service client
- Consignes de sécurité importantes
- Caractéristiques techniques de l'appareil
- Conditions d'installation
- Consignes d'installation
English40
Installation instructions
Installation instructions
Final installation
Anti-Tip Foot
(location varies)
1. Peel the protective coating off of the
range, including the door.
2. Measure from the floor to the
countertop. Adjust the leveling legs as
required to position the trim around
the cooktop even with or above the
countertop.
3. To install the Anti-tip bracket, release
the leveling leg using pipe wrench
because Loctite is applied on Bolt for
vibration unlocking.
Locate the anti-tip foot on the back of
the range and lower (turn) it until it is
1/16” (2 mm) off the floor.
Anti-tip
bracket
Anti-tip foot
4. Carefully slide the range into position
into the cutout. The anti-tip foot should
engage the anti-tip bracket. Using a
flashlight look underneath the range
and verify that the bracket covers the
anti-tip foot.
5. Use a level to make sure that the range
does not tilt front to back or side to
side. Re-adjust the legs to level and
change the height if necessary.
6. After installing and leveling the range,
install front leg covers (right and left).
Install_NX9900R_PRORANGE_DOP36M96_DA_DG68-01106C-02_EN+MES+CFR.indb 40 2019-08-13 6:30:53