User Manual

English 51
Troubleshooting
Troubleshooting
Troubleshooting
Dacor works hard to ensure that you don’t have problems with your new electric
oven. If you run into unexpected trouble, look rst for a solution in the tables
below. If you’re still having trouble after trying the suggested solution, call Dacor
Contact Center at 833-35-ELITE (833-353-5483).
Gas safety
Problem Possible cause Solution
You smell gas.
The surface burner knob is
not in the OFF position and
the burner is not lit.
Turn the burner knob to OFF.
There is a gas leak.
Clear the room, building, or area of all
occupants. Immediately call your gas
supplier from a neighbor’s phone. Do
not call from your phone. It is electrical
and could cause a spark that could
ignite the gas. Follow the gas supplier’s
instructions. If you cannot reach your
gas supplier, call the re department.
Surface burner
Problem Possible cause Solution
All burners do not
light.
The power cord is not
plugged into the electrical
outlet.
Make sure the electrical plug is
plugged into a live, properly grounded
outlet.
A fuse in your home may
be blown or the circuit
breaker may have tripped.
Replace the fuse or reset the circuit
breaker.
The gas supply is not
properly connected or
turned on.
See the Installation instructions that
came with your range.
Replacing the oven lights
Oven lights (2 Locations)
There are 2 oven lights, one on each side oven wall. To replace a light, follow these
steps:
1. Hold the lower end of the side oven
light cover with one hand, and then use
a at-sharp tool such as a table knife to
remove the cover as shown.
2. Replace the side oven light.
3. Reinsert the light cover.
CAUTION
To prevent electric shock, make sure the Electric oven is power off and cool before
replacing the oven light.
NOTE
• The oven lights do not operate during a self-cleaning cycle.
• Remove the racks if they prevent you from accessing an oven light.
DOP36P86DLS_DA_DG68-01105E-00_EN+MES+CFR.indb 51 2020-07-06 오후 3:53:58