Install Guide

English 27
Installation instructions
Adjustment air shutter (Bake Burner)
1. Remove 2 screws of Cavity Floor and
remove Cavity Floor.
2. Remove 2 screws of Bracket Base and
remove Bracket Base.
3. Loose Locking screw of Bake Burner
and, adjust air shutter.
Locking screw
To adjust the shutter, loosen the locking
screw and rotate the shutter towards the
open or closed position as needed. If ames
are lifting off the burner ports, gradually
reduce the air shutter opening until the
ames are stabilized.
If ames are too yellow and/or too large,
gradually increase the air shutter opening
until the ames have approximately a 1 in
blue cone.
NOTE
If the range is set up for natural gas, the
ames should burn with minimal yellow
tipping. If the range is set up for LP gas,
small yellow tips at the end of the cones are
normal.
Locking screw
After the ames are adjusted properly, shut
off the oven, retighten the locking screws,
replace the oven bottom and racks, and
close the oven door.
Install_DOP36P86GLS_DG68-01106D-00_EN+MES+CFR.indb 27 2020-07-01 오후 4:07:35