Installation Instructions Distinctive ™ 30 - Inch Gas Range For use with models DR30GS, DR30GFS, DR30GIS and DR30GIFS THIS APPLIANCE HAS BEEN TESTED IN ACCORDANCE WITH THE LATEST EDITION OF ANSI Z21.1a-2011 STANDARD FOR HOUSEHOLD GAS COOKING APPLIANCES. Part No. 105908 Rev.
Table of Contents Important Safety Instructions...................................................... 1 Important Information About Safety Instructions.............................1 General Safety Precautions............................................................ 2 Installation Specifications............................................................4 Product Dimensions........................................................................4 Electrical Power Supply Requirements........................
Important Safety Instructions Important Information About Safety Instructions The Important Safety Instructions and warnings in this manual are not meant to cover all possible problems and conditions that can occur. Use common sense and caution when installing, maintaining or operating this appliance. Always contact the Dacor Customer Service Team about problems or conditions you do not understand. Safety Symbols and Labels DANGER Immediate hazards that WILL result in severe personal injury or death.
Important Safety Instructions General Safety Precautions To reduce the risk of fire, explosion, electric shock, serious injury or death when installing or using this appliance, follow basic safety precautions, including the following: WARNING • Read the accompanying use and care manual completely before operating this appliance. • Keep packaging materials away from children. Plastic sheets and bags can cause suffocation. • If you receive a damaged product, immediately contact your dealer or builder.
Important Safety Instructions WARNING WARNING • Do not expose the knobs to direct flame, hot utensils or other sources of heat. TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE: • Always ensure that the light fixture lens cover is in place when using the oven. The lens cover protects the light bulb from breakage caused by high oven temperatures or mechanical shock. a. SMOTHER FLAMES with a close-fitting lid, cookie sheet or metal tray, then turn off the burner.
Installation Specifications Product Dimensions All tolerances: ±1/16” (±1.6 mm), unless otherwise stated Front of open door Front of knobs 45 9/16” (115.7 cm) 28 9/16” (72.5 cm) 26 1/8” (66.4 cm) 24” (61.0 cm) Front panel Rear of front panel 1 1/8” (2.9 cm) Backguard thickness 9” (22.9 cm) Grates extend Backguard* 1” above trim 3” (7.6 cm) backguard* DR30GI[F]S: 1/4” (6.
Installation Specifications WARNING • • • • • • This appliance must be installed and electrically grounded in conformance to local codes. In the absence of local codes, the appliance installation must conform with the National Fuel Gas Code, ANSI Z223.1/NFPA 54 and the National Electrical Code, ANSI/NFPA 70.
Installation Specifications Cabinet Layout WARNING All tolerances: +1/16” (+1.6 mm), -0 unless otherwise stated • B 13” (33.0 cm) max.4 • Back wall immediately behind range6 • Carefully check the location where the range is to be installed. For best performance, the range should be placed away from drafts that may be caused by doors, windows and heating and air conditioning outlets.
Installation Specifications Self-Rimming Installation Cutout Options (Models DR30GIS and DR30GIFS Only) For all self-rimming installations: Countertop height: 34 3/4” (88.3 cm) min. 36 7/8” (93.7 cm) max. Countertop thickness: 1 5/8” (4.1 cm) max. 10” min. (25.4 cm) to any combustibles above counter both sides 10” min. (25.4 cm) Rear wall*or 3/4” min. (1.9 cm) to any combustibles countertop edge countertop overhang above counter both sides Non-combustible rear wall required * 25 5/8” max. (65.
Installation Specifications Gas and Electrical Locations • • Dacor recommends that utility access for all models be installed in an adjacent cabinet, as shown on page 6. If the utilities are installed behind the range, the installation must allow for the following: • CL 10” (25.4 cm) ◊ 10” (25.4 cm) Access to the gas shut-off valve when the unit is installed. ◊ Access to the electrical outlet, when the range is in place.
Installation Instructions Four (4) plastic anchors are provided along with three sizes (4 each) of #8 or #12 Phillips head screws for attaching the anti-tip bracket to the floor. Use both the anchors and four (4) of the #8 screws when attaching the bracket to a concrete sub-floor. Do not use the anchors when attaching to a wood sub-floor. Side View Attaching the bracket to a concrete floor: • Drill four (4) 3/8” diameter countersink holes through any existing floor covering to the concrete slab below.
Installation Instructions Installing the Anti-Tip Bracket on the Wall 1. Determine the suitability of wall mounting the anti-tip bracket. To use the wall mount option, the range front panel must not be more than 27 3/8” (69.5 cm) from the wall and the bracket screws must be able to thread into the base plate inside the wall behind.
Installation Instructions Adjust the Range Height Door Removal 1. For stand alone configurations, raise the range until the top of the trim around the cooktop is at least the same height as the countertop. For self-rimming configurations, raise the range until the bottom of the trim surrounding the cooktop is even with the countertop. To adjust the height, turn the foot on the bottom of each leg as shown below. Remove the door to make the range easier to move during the installation process.
Installation Instructions Gas Connection WARNING • Make sure the gas is turned off at the gas supply valve before connecting the gas line. • Verify that the gas supply meets specifications before connection. See page 5. • Do not apply excessive pressure when tightening gas connections and fittings. • Do not use Teflon tape or plumber’s putty on flexible gas line connections. • Test the gas lines for leaks as instructed before use.
Installation Instructions Moving the Range to Final Location Re-Installing the Door 1. Peel the protective plastic coating off of the range, including the range door. WARNING 2. Uncoil the power cord and route it to the electrical outlet so that it does not become trapped behind the range when it is pushed back. Do not connect the power plug until you are ready to verify proper operation. To avoid personal injury or damage to the door from it falling off its hinges: 3.
Installation Instructions Cooktop Assembly WARNING Never attempt to operate the range’s cooktop with any of the burner rings, burner caps or grates removed. 1. Remove the burner rings, burner caps and grates from their shipping cartons. 2. Install the burners as shown. Gently twist each piece back and forth after installation to make sure it is properly seated. A small gap below the bottom of the burner ring is normal. 3. Gently set the grates on top of the spill tray.
Installation Instructions Verifying Proper Operation WARNING Before operating the range, read the accompanying use and care manual completely. 1. Before beginning the test procedure, make sure all range control valves are in the “OFF” position, and all burner rings, burner caps and grates are properly positioned on the spill tray. 10. Turn the oven control knob to the BROIL position. The bake burner should turn off. Both the oven control knob and the oven ON indicator light should be illuminated.
Installation Instructions Installation Checklist WARNING To ensure a safe and proper installation, the installer must perform the following checklist to ensure that no part of the installation has been overlooked. Proper installation is the responsibility of the homeowner. □□ Has the plastic coating been peeled off of the outside of the range? Have all packaging materials been removed from inside the oven? □□ Are all leveling legs extended down to make contact with the floor? Is the unit level? See page 8.
Dacor ● 14425 Clark Avenue, City of Industry, CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.