Manuals(0)

ManualsBrandsDacor ManualsBuilt-In Full Refrigerators / FreezersDacor Modernist 36" Built-In Panel Ready Column Freezer

Refrigerator Models: All DRR, DRZ & DRW Models

Installation Preparation:

These instructions provide details which will allow Column Refrigeration

models of any size (18”, 24”, 30” & 36”),

utilizing custom panels only

to be

combined / paired together in arrangements as depicted below.

Note: Modernist style or handle-less door handle options are recommended for

use in Trio installation configurations. Pro style door handles should not be used.

Installation Kit pt.# RAC00TCAAAA - Includes:

1. Installation Instructions

2. Upper Joining Bracket

3. Right Adjustable Bracket

4. Left Adjustable Bracket

5. Rear Joining Bracket

Additional Items Needed:

Dacor-Pairing Installation Kit pt.#

RAC00CPAAAA (Qty. 2)

Refer to the installation manuals supplied with the units for complete installation instructions.

Triple Column Refrigerator

Installation Instructions

Summary of content (4 pages)

PAGE 1
Refrigerator Models: All DRR, DRZ & DRW Models Triple Column Refrigerator Installation Instructions Refer to the installation manuals supplied with the units for complete installation instructions. Installation Preparation: These instructions provide details which will allow Column Refrigeration models of any size (18”, 24”, 30” & 36”), utilizing custom panels only to be combined / paired together in arrangements as depicted below.
PAGE 2
Instructions: Cabinetry requirements 1. Confirm depth of cabinet opening. Minimum cabinet depth 25” If cabinetry depth is greater than 25” you will need to install an adjustable bracket (figure 1) to the top rear on each of the columns to prevent the joined units from potentially migrating backwards into the cabinetry opening at their union over time. Figure 1. Cabinetry Depth Min. 25” Unit Depth 25” 2.
PAGE 3
4. Place the right adjustable bracket on the upper left corner of the column and place the left adjustable bracket on the upper right corner of the column. 5. Place the Upper Joining Bracket over the two adjustable brackets aligning the center holes of the Joining Bracket with the holes in each of the columns . Insert the two screws saved from step 3 and fasten the brackets together.
PAGE 4
9. Insert the Lower Front Joining Bracket so that it will attach behind the kick plates as shown. 10. One at a time, place the kick plates in front of the bracket and re-affix each in place with the original screws that held the kick plates in place. 11. Complete the rest of the column installation process as outlined in the unit’s Installation Manuals.