Manuals(0)

Instructions:
Cabinetry requirements
1. Confirm depth of cabinet opening.
Minimum cabinet depth 25”
If cabinetry depth is greater than 25” you will need to install an adjustable bracket
(figure 1) to the top rear on each of the columns to prevent the joined units from
potentially migrating backwards into the cabinetry opening at their union over time.
Figure 1.
2. On the adjoining side of each column refrigerator to be paired, remove the
screw at the top rear corner. Set the removed screws aside for reuse in
step 6.
3. Carefully roll the attached columns into the cabinetry opening after making sure
that both units are plugged in. Slowly raise the units to the proper height by
alternately raising the leveling legs bit by bit until proper height has been
achieved.
Unit Depth 25”
Cabinetry
Depth Min. 25”