Installation Guide

6
Installation Specifications
Cutout Dimensions
All tolerances: +1/16” -0” unless otherwise noted.
IMPORTANT: Be careful to choose the correct cutout diagram on page 7.
There are two cutout styles: a square cutout and a knotched cutout.
Use the table below to determine the countertop cutout type and the dimensions for the installation.
1. Find your specific DTCT model that matches your specific configuration setup.
2. Choose the square or notched cutout type according to your configuration (see below).
3. Carefully double check all dimensions against the table below and the correct diagram before cutting the countertop.
CUTOUT TYPE AND DIMENSIONS
Configuration
Cutout
TYPE
C Min. D E F G H
DTCT304G without
downdraft
Square
2 7/8 in
(7.3 cm)
19 3/4 in
(50.2 cm)
27 3/4 in
(68.6 cm)
NA NA NA
DTCT304G with
ERV3015 and PRV30
Square
3/8 in
(1.0 cm)
22 1/2 in
(57.2 cm)*
27 3/4 in
(68.6 cm)
NA NA NA
DTCT304G with RV30 Square
5/8 in
(1.6 cm)
22 1/4 in
56.5 cm)*
27 3/4 in
(68.6 cm)
NA NA NA
DTCT365G without
downdraft
Square
2 3/8 in
(6.0 cm)
19 3/4 in
(50.2 cm)
33 5/8 in
(85.4 cm)
NA NA NA
DTCT365G with
ERV3615 and PRV36
Square
3/8 in
(1.0 cm)
22 1/2 in
(57.2 cm)*
33 5/8 in
(85.4 cm)
NA NA NA
DTCT365G with RV36 Square
5/8 in
(1.6 cm)
22 1/4 in
(56.5 cm)*
33 5/8 in
(85.4 cm)
NA NA NA
DTCT466G without
downdraft
Square
2 7/8 in
(7.3 cm)
19 3/4 in
(50.2 cm)
44 1/2 in
(113.03 cm)
NA NA NA
DTCT466G with PRV46 Notched
3/8 in
(1.0 cm)
22 1/2 in
(57.2 cm)*
44 1/2 in
(113.03 cm)
43 1/2 in
(110.5 cm)
5/8 in
(1.6 cm)
2 5/8 in **
(6.7 cm)
DTCT466G with RV46 Notched
5/8 in
(1.6 cm)
22 1/4 in
(56.5 cm)*
44 1/2 in
(113.03 cm)
43 1/2 in
(110.5 cm)
5/8 in
(1.6 cm)
2 3/8 in **
(6.0 cm)
* Total cutout depth accommodates both the cooktop and downdraft.
** IMPORTANT: Notch depth is included in total cutout depth (D).
DO NOT add notch depth to total cutout depth (D).