Installation Guide

Table Of Contents

Converting the pressure regulator

NOTE

If you use LP gas, these steps and conversions must be made before adjusting the flames.

1. Using your fingers, turn the cap. And carefully look at the spring retainer to locate the

NAT or LP position.

NAT

NAT. Position

L.P./Propane

Position

Pressure Regulator

Spring

Retainer

NAT

Cap

Gasket

2. Rotate the spring retainer 90°, and pull it from the cap. Turn the spring retainer over

so LP shows, re-insert it in the cap, then rotate it 90° into position.

3. Screw the cap back onto the regulator, and tighten the cap.

English