Combined Configuration Drop-In Cooktop_ERV-PRV_Wall Oven

All specications subject to change without notice.
Phone: [phone]www.dacor.com
PLANNING
GUIDE
Finished floor
Countertop
Cooktop
Wall
Wall board
Wall oven
A
B
C
Cabinet face
*
Cabinet face
Distance from
finished
countertop to
oven platform
28 1/4”
(71.8 cm) min.
1" (2.5 cm) min.
oven platform height
1 3/4” (4.4 cm)
for EO/MO series
*DYO series only: 1" (2.5 cm) min.
internal cabinet depth
Cooktop/vent cutout
Adjustable support leg
Backsplash
Downdraft vent
Stiffner
ERV/PRV series
downdraft vent
3/8” (1.0 cm) min.
countertop overhang
3/8” (1.0 cm) min. gap
behind downdraft vent
to allow for stiffner
Rear exhaust
configuration shown
DCT/ETT/MET/RGC/
RNCT/SGM drop-in cooktop
Dacor DO, DYO, EO, EORS,
MOH, MORS, MOV, RO or ROV
series single wall oven
Support platform
3/4” (1.9 cm) min. thickness
Back of
cabinet interior
COMBINATION INSTALLATIONS
Drop-In Cooktop with ERV/PRV Series
Downdraft Vent and Single Wall Oven
Document # PGCI-010
Revised 03/11/14 Page 1/3
CUTAWAy SIDE VIEW
COUNTERTOP CUTOUT - TOP VIEW
COUNTERTOP CUTOUT - ISO VIEW
All tolerances: +1/16” (+1.6 mm), -0, unless otherwise stated
WARNING
• Observe all governing codes and ordinances during
planning and installation. Contact your local building
department for further information.
• All appliances must be installed in accordance with the
accompanying installation instructions.
3/8" min.
(1.0 cm)
Cabinet face
below countertop
Downdraft mounting
notch, required on some
configurations
E
C
B
D
F
Notches for
downdraft vent
not required with
some cooktops
■ See following pages for dimension table and compatible downdraft
vent models.
■ This configuration is not compatible with cabinet blower model
CABP3.
*
*
* When the cooktop chassis is about the same width as the
downdraft vent chassis, the cutout does not need to be notched
(cutout is rectangular). In cases were the cutout is rectangular,
dimension D on the following pages will be “NA” and dimension E
will be equal to dimension F.