Use and C are Manual Wine Dispensing System Model DYWS4 Shown with optional wall mount trim kit Ta b l e o f C o n t e n t s Important Safety Instructions.................................. 1 Getting to Know Your Wine Dispensing System........ 3 Setting Up Your Wine Dispensing System................ 7 Operating Your Wine Dispensing System................ 8 Parts and Accessories......................................... 22 Before You Call for Service.................................. 22 Warranty and Service.
READ AND SAVE THESE INSTRUCTIONS © 2013 Dacor, all rights reserved
Important Safety Instructions Installer: Leave this manual with the appliance. Important Information About Safety Instructions Consumer: Read this use and care manual completely before using this appliance. Save it for future reference. It contains important use and care information. The Important Safety Instructions and warnings in this manual cannot cover all possible problems and situations that can occur.
Important Safety Instructions General Safety Precautions To reduce the risk of fire, electric shock, serious injury or death when using your wine dispensing system, follow basic safety precautions, including the following: WARNING WARNING • This appliance must be properly installed according to the accompanying installation instructions before use. • Read this use and care manual completely before operating this appliance.
Getting to Know Your Wine Dispensing System Introduction • There are three factors that affect wine preservation; oxidation, temperature and light. Your wine dispensing system limits the effects of these factors to provide a winery fresh taste for up to 60 days after opening the bottle. Your wine dispensing system uses argon gas, which is heavier than air. The system injects argon into the wine bottle and displaces any residual air so that the wine is exposed only to the argon, not oxygen.
Getting to Know Your Wine Dispensing System System A Main Power Switch (under spout cover) Switch Positions ON SERVICE MODE RESERVED OFF B F For use by authorized service personnel only G C D E A Main power switch Use the switch to turn the system ON and OFF and to access the main service menu (see page 11). B Control panel The control panel has a display and set of pour control buttons for each wine bottle.
Getting to Know Your Wine Dispensing System Control Panel H J DACOR 2008 Red Wine 1oz 3oz P K C L 6oz J M H Display The display provides the system status and information for the wine bottle installed below the particular display. It can be programed with specific information about each type of wine being served (see page 12). The display is also used for programming the various system functions.
Getting to Know Your Wine Dispensing System Dispensing Head H C B D A E F G A Spout The stainless steel spout protrudes from the front of the unit when the spout cover H is closed and delivers the wine to your glass when one of the pour buttons above it is pushed. B Head cap The removable head cap allows the inside of the dispensing head to be cleaned. C Rotor switch The rotor switch is used by your dispensing system to control wine and argon gas flow when the system is in use.
Setting Up Your Wine Dispensing System 5. Open the door on the front of the unit. Swing the spout cover to the up position as shown on the facing page. Preparing to Use Your Wine Dispenser for the First Time ON WARNING Do not use any power supply other than the one provided with the system or a Dacor approved replacement. Do not attempt to modify or bypass the power supply. OFF 1.
Setting Up Your Wine Dispensing System Preparing to Use Your Wine Dispenser for the First Time (cont.) 9. Find the gas regulator assembly that comes with the unit. Regulator adjustment knob WARNING To avoid personal injury, use only the included gas pressure regulator or a Dacor specified replacement. 11. Make sure the regulator adjustment knob is turned all the way in the OFF direction. 12. Connect the gas supply line from the wine dispensing system to the gas connector on the regulator assembly.
Operating Your Wine Dispensing System 6. The gasket must be fully un-tightened (collar all the way up, touching the main body) before you insert the head. Turn the collar as shown until it stops. Attaching the Clean-Pour Dispensing Heads CAUTION To avoid dropping a wine bottle when carrying it around with the dispensing head attached, always hold the bottle itself (not just the head). 1. Open the bottle and place it on a flat, dry surface. 2.
Operating Your Wine Dispensing System Attaching the Dispensing Heads (cont.) Basic Operation NOTE: The control panel must be unlocked for the unit to operate. If the control panel is locked, see page 15 (Unlocking the Control Panel). 11. Inspect the dispensing head. If more than three threads are visible between the top of the collar and the bottom of the main body, either the gasket is damaged or the gasket could be the wrong size.
Operating Your Wine Dispensing System 5. Push the purge (P) button next to the display above the bottle that has just been inserted, once. The food grade argon will replace the air in the bottle, assuring preservation. DACOR NOTE: Dacor recommends replacing the pickup tube with each bottle change, but the pick-up tube may be washed out in a mild solution of warm water and dishwashing soap, rinsed out and reused. 6.
Operating Your Wine Dispensing System 3. Push the center button below the display repeatedly to select ±1 Year, ±10 Year or No Year. When the display is set to ±10 Year, the display jumps 10 years every time the up (▲) and down (▼) buttons on the right are pushed. You must push Select Wine to exit after changing the year. NOTE: When large year changes need to be made, adjust the last digit first then the 10 year increments.
Operating Your Wine Dispensing System ◊ To leave the generic display on the screen (for example White Wine) push Exit. Select Wine ▼ Exit White Other Exit White Red Set Year Set VOL 3. Push the button for which you want to adjust the pour volume (for example 1oz). ◊ To select a specific wine type push the up (▲) and down (▼) buttons on the right to select a specific wine (for example Sauvignon Blanc), then push Exit. A list of the specific wine types programmed into the system appears on page 18.
Operating Your Wine Dispensing System Changing Individual Bottle Settings (cont.) 4. Push Exit. • When you are done adjusting the bottle position settings. Slide the power switch up to the ON position. Turning Pour Detect On or Off • Lower the spout cover and close the front door. The wine dispensing system can detect if there is a fault in the pouring capabilities of each bottle position. Control Panel Settings 1. Turn Pour Detect on or off from the main service menu (see page 11).
Operating Your Wine Dispensing System Locking the Control Panel Setting the System Temperature, System Fan and Temperature Scale(F/C) The control panel lock may be set from the front panel to avoid undesired operation. The system has three temperature settings, OFF, ON and MAX. When the the system is set to ON, the fan will run less making the system quieter, but the bottle bay will take longer to cool. To lock the control panel: 1.
Operating Your Wine Dispensing System Accessing the temperature/fan settings (cont.) 5. To select the fan setting, push the bottom left button to switch between the OFF, ON and MAX settings. The higher the fan setting, the more fan noise will be heard. 3. Set desired “Wine” temperature by pushing the buttons next to the up (▲) and down (▼) symbols on the display repeatedly.
Operating Your Wine Dispensing System System Name Change 6. Slide the power switch up to the ON position. The new system name will appear on all four displays. If you want you can change the name on the top of the display from DACOR to anything you want, up to 20 characters long (for example Our Wine Cellar). 7. Lower the spout cover and close the front door. To change the system name display: Display Contrast/Brightness Settings 1.
Operating Your Wine Dispensing System Pre-programmed Wine Selections Red Wines Barolo Bordeaux Brunello Burgundy Cabernet Franc Cabernet Sauvignon Chianti Grenache Malbec Merlot Mourvedre/Mataro Nebbiolo Petit Verdot Petite Sirah Primitivo Sangiovese Shiraz Syrah Tempranillo Zinfandel Pino Blanc Riesling Sauvignon Blanc Viognier Pinot Gris White Zinfandel Fume Blanc Ice Wine Rose Colombard Cortese Corvina Counoise Duriff Eiswein Fiano Frascati Gamay Garganega Grappa Grenache Blanc Grenache Gris Grign
Care and Cleaning Cleaning the Dispensing Heads Cleaning • WARNING 1. Remove the pick up tube and discard or wash it out in a mild solution of warm water and dishwashing soap, then rinse it out. Clean only the parts of the appliance listed in this manual. Clean them only in the manner specified. Do not use any chemicals, abrasive materials or razor blades to clean any part of the appliance.
Care and Cleaning Cleaning the Control Panel 2. Remove gasket from stem. 3. Select the gasket color to be used (green, red or white). 4. After placing the gasket onto the stem, carefully thread the nut back onto the stem by turning clockwise. It should thread easily. IMPORTANT: Do not force. Make sure the nut is secure. The display and touch panel may be wiped with a damp clean cloth, as needed. Do not use chemicals or any abrasive materials.
Care and Cleaning 4. Remove the plastic cap from the top of the new gas cylinder. Replacing the Gas Cylinder 5. Insert the top of the new gas cylinder into the bottom of the gas regulator assembly and turn clockwise until snug. Do not over-tighten. DANGER IMPORTANT: Use only the argon gas cylinder type specified in this manual with this appliance. Use of any other type gas or cylinder may result in explosion, fire and personal injury. 6. Turn the regulator knob in the ON direction until it stops. 7.
Parts and Accessories Description Dacor Part Number Dacor Stainless Steel Cleaner A302 Package of pickup tubes (package of 10) AWSPT Silicon spray, food grade (11 oz.
Before You Call for Service Problem Empty bottle message/ red light on solid in bottle position. May Be Caused By What to Do Wine bottle empty. Replace the wine bottle. See page 11. Pickup tube not installed. Remove bottle and dispensing head. Remove dispensing head from bottle and check to make sure pickup tube is attached. Dispensing head is loose. Check to make sure head is tight on bottle. See page 9. Gas regulator knob in OFF position. Turn gas regulator knob in ON direction until it stops.
Before You Call for Service Problem May Be Caused By What to Do System is noisy. Cooling fans set too high. See page 15 to change the fan setting. NOTE: Changing the fan setting may extend the time it takes for the bottle bay to cool after door openings and closings. Bottle will not slide into bottle bay. Cap on clean pour head misaligned. Check that the cap and rotor switch are in the correct position. See page 9. Wine comes out during purge or clean process. New wine bottle is very full.
Warranty and Service What Is Not Covered Warranty • CERTIFICATE OF WARRANTIES: DACOR WINE DISPENSING SYSTEM Slight color variations may be noticed because of differences in painted parts, kitchen lighting, product placement and other factors; this warranty does not apply to color variation. • WITHIN THE FIFTY STATES OF THE U.S.A., THE DISTRICT OF COLUMBIA AND CANADA: Service calls to educate the customer on proper use and care of the product.
Notes 26
Notes 27
28
fold here NO POSTAGE NECESSARY IF MAILED IN THE UNITED STATES BUSINESS REPLY MAIL FIRST-CLASS MAIL PERMIT NO 1600 CITY OF INDUSTRY CA POSTAGE WILL BE PAID BY ADDRESSEE DACOR ATTN WARRANTY PROCESSING DEPT PO BOX 90070 CITY OF INDUSTRY CA 91715-9907
Please visit www.dacor.com to activate your warranty online. WARRANTY INFORMATION IMPORTANT: Please rest assured that under no conditions will Dacor sell your name or any of the information on this form for mailing list purposes.
