Specifications

ManualsBrandsDacor ManualsRefrigeratorEF36BNF

Part No. 106081 Rev. C/13036904

In s t a l l a t I o n In s t r u c t I o n s

36 In c h re f r I g e r a t o r

For Use With Models: EF36BNF, EF36LNF, EF36RNF, PF36BNDF

Francis - Voir Page 9

Summary of content (10 pages)

PAGE 1
I n stall at i o n I n st r u ct i o n s 36 I n c h R e f r i g e r ato r For Use With Models: EF36BNF, EF36LNF, EF36RNF, PF36BNDF Francis - Voir Page 9 Part No. 106081 Rev.
PAGE 3
Table of Refrigerator Safety........................................................................1 Installation Recommendations....................................................1 Design Specifications...................................................................2 Door Swing Dimensions.............................................................. 2 Product Dimensions.....................................................................2 Installation Specifications..................................
PAGE 4
Design Specifications Product Dimensions ◊ The depth from the front of the door (w/o door handles) to the back of the refrigerator chassis is 26 7/8” (683 mm). ◊ The depth of the cabinet less the door is 24 1/8” (613 mm). ◊ The power cord is 60” (1524 mm) long.
PAGE 5
Installation Specifications Cabinet Layout Reverse osmosis water supply ◊ A grounded three prong non-GFCI electrical outlet must be provided and should be in a location that allows the refrigerator to be connected without an extension cord. See “Electrical Requirements” for additional information. ◊ The plumbing for the water line can come through the floor flush to or from the back wall.
PAGE 6
Installation Instructions IMPORTANT: If you receive a damaged product, immediately contact your dealer or builder. Do not install or use a damaged appliance. Door and Drawer Front Removal Some installations require door and drawer front removal before transporting the refrigerator through doorways to the location where it will be used. WARNING TO REMOVE THE DRAWER FRONT: 1. Pull the freezer drawer completely open. 2. Tilt the lower basket forward and lift to remove. 3.
PAGE 7
Reinstalling Installation Instructions the Drawer Front After the moving the refrigerator to the location where it will be used, reinstall the door(s) and freezer drawer front. 1. Slide the screws on the back of the drawer front into the slots in the drawer brackets on both sides. You may need to move the bottom of the bracket around slightly to get the slot to line up with the screw. Reinstalling the Door(s) Install the hinge assemblies: 1.
PAGE 8
Connecting Installation Instructions the Materials Needed: Water Supply 1 2 • 1⁄4” outer diameter flexible copper tubing • Shut-off valve (requires a 1⁄4” hole to be drilled into water supply line before valve attachment) • Adjustable wrench • 1⁄4” hex nut driver 6. Slide the brass nut over the sleeve and screw it into the inlet port. 7. Place an adjustable wrench on the nut (1) attached it to the plastic waterline. Maintain position. 1 2 8.
PAGE 9
Move Unit Installation Instructions to Final Position When Moving Your Refrigerator: Your refrigerator is heavy. When moving the refrigerator for cleaning or service, be sure to protect the floor. Always pull the refrigerator straight out when moving it. Do not wiggle or “walk” the refrigerator when trying to move it. Floor damage could occur. Leveling 1. Remove the base grille. Grasp the grille firmly an pull it toward you.
PAGE 10
Installation Instructions Installation Checklist The importance of the proper installation of your Dacor refrigerator cannot be overemphasized. Proper installation is the responsibility of the homeowner. IMPORTANT: To ensure a safe and proper installation, the following checklist should be competed by the installer to ensure that no part of the installation has been overlooked.