Refrigerator Installation Instructions

ManualsBrandsDacor ManualsRefrigeratorEF36BNFSS

INSTALLATION

INSTRUCTIONS

Preference™ Handle Kit,

PN AFP36H3

REFRIGERATOR MODELS: EF36BNFSS & PF36BNDFXX*

*Where XX indicates color

Installation Preparation (Model EF36BNFXX Only.

For Model PF36BNDFXX, skip to Step 3):

STEP 1: Using a T20 Torx driver, remove the six (6)

handle mounting studs from the front of the

refrigerator. Retain the Torx mounting screws.

Discard the studs.

Handle Mounting

Stud Locations

Existing handle

mounting screw

(keep)

Existing mounting

stud (discard)

Part No. 102864 Rev. C

Parts Included

Preference Style Handles (2 Large, 1 Small)

Tools Required

3/32” Allen wrench (not supplied)•

T20 Torx driver (EF36BNFSS Only)•

Summary of content (4 pages)

PAGE 1
REFRIGERATOR MODELS: EF36BNFSS & PF36BNDFXX* *Where XX indicates color Preference™ Handle Kit, PN AFP36H3 INSTALLATION INSTRUCTIONS Tools Required • • 3/32” Allen wrench (not supplied) T20 Torx driver (EF36BNFSS Only) Parts Included Preference Style Handles (2 Large, 1 Small) Installation Preparation (Model EF36BNFXX Only. For Model PF36BNDFXX, skip to Step 3): STEP 1: Using a T20 Torx driver, remove the six (6) handle mounting studs from the front of the refrigerator.
PAGE 2
Refrigerator Handle Kit Installation Instructions STEP 2 (Model EF36BNFSS only): Using the T20 Torx driver and the screws removed in step 1, install the six (6) short mounting studs from the kit in the locations shown. Existing handle mounting screw New mounting stud from kit Handle Mounting Stud Locations Bottom (Freezer) Handle Installation STEP 3: Find the smallest of the three handles in the kit box.
PAGE 3
Refrigerator Handle Kit Installation Instructions Top Right Handle Installation STEP 7: Mount the handle to the right door by sliding the holes on the back over the handle mounting studs on the right door. Make sure the set screw holes face toward the center of the refrigerator. Loosen the set screws if necessary to allow the handle to slide into place. STEP 8: Carefully tighten the set screws into place using the 3/32” Allen wrench. Be careful not to scratch the finish.
PAGE 4
Dacor ● 1440 Bridge Gate Drive, Diamond Bar, CA 91765 ● Tel: (800) 793-0093 ● FAX: (626) 403-3130 ● www.Dacor.