36 Inch Refrigerator For use with model EF36IWF Part No. 106623 Rev.
Table of Contents Refrigerator Safety........................................................................1 Proper Disposal of Your Refrigerator .........................................1 Design Specifications...................................................................2 Product Dimensions.....................................................................2 Installation Specifications.........................................................2-3 Tools and Parts.................................
Refrigerator Safety Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.
Design Specifications Product Dimensions • The depth from the front of the door (w/o door handles) to the back of the refrigerator chassis is 26 1/2” (673 mm). • The depth of the cabinet less the door is 23 3/4” (603 mm). • The power cord is 60” (1524 mm) long. • The height from the top of the refrigerator to the floor with the leveling legs in the fully extended position is 70 3/4” (1797 mm) at the front of the unit. • The refrigerator width from edge to edge is 35 5/8” (905 mm).
Installation Specifications Cabinet Layout Reverse osmosis water supply • Locate the refrigerator so that it may easily be pulled out from the wall if service becomes necessary. • A grounded three prong non-GFCI electrical outlet must be provided and should be in a location that allows the refrigerator to be connected without an extension cord. See Electrical Requirements for additional information. • The plumbing for the water line can come through the floor flush to or from the back wall.
Installation Instructions IMPORTANT: • If you receive a damaged product, immediately contact your dealer or builder. Do not install or use a damaged appliance. • Read all directions before you begin. Move Refrigerator into House WARNING Unpack the Refrigerator WARNING Tip Over Hazard Refrigerator is top heavy and tips easily when not completely installed. Tip Over Hazard Refrigerator is top heavy and tips easily when not completely installed. Use two or more people to move and install refrigerator.
Installation Instructions Door and Drawer Front Removal Some installations require door and drawer front removal before transporting the refrigerator through doorways to the location where it will be used. IMPORTANT: • Keep the refrigerator doors closed until you are ready to lift them free from the cabinet. • Provide additional support for the refrigerator door while the hinges are being removed. Do not depend on the door gasket magnets to hold the door in place while you are working. 1.
Installation Instructions Connecting the Water Supply Reinstalling the Doors After the moving the refrigerator to the location where it will be used, reinstall the door(s) and freezer drawer front. 1. Replace the rollers. Read all directions before you begin. IMPORTANT: If you turn the refrigerator on before the water line is connected, turn the ice maker OFF. Connect to Water Line 2. Slide the screws on the back of the drawer front into the slots in the drawer brackets on both sides.
Installation Instructions Connect to Refrigerator Style 2 Depending on your model, the water line may come down from the top or up from the bottom. Follow the connection instructions for your model. 1. Unplug the refrigerator from the electrical outlet. Style 1 2. Create a service loop with copper tubing (minimum 2 foot/61 cm diameter). Avoid kinks in the copper tubing when bending it into a service loop. Do not use plastic tubing. 1. Remove the plastic cap from the water supply connection.
Installation Instructions Connecting the Water Supply (Continued) 6. Slide the brass nut over the sleeve and screw it into the inlet port. Plug in Refrigerator WARNING 7. Place an adjustable wrench on the nut attached it to the plastic waterline. Maintain position. 8. Using a second adjustable wrench, turn the lower nut counterclockwise and fully tighten it while holding the upper nut in place. Do not overtighten. Electrical Shock Hazard Plug into a grounded 3 prong outlet.
Installation Instructions Leveling Complete Installation WARNING 1. Turn the water supply line valve to the open position. 2. Wait a few minutes. Check the water line connections for leaks. 3. Remove all boxes, parts packages and packing materials from the interior of the refrigerator. Tip Over Hazard 4. See the Care and Cleaning section in the use and care manual for instructions. Remove the film and cardboard from the grille and doors or door frame, depending on your model.
Dacor ● 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.Dacor.
