Specifications

17
IMPORTANT:
Install the custom handles prior to installing the panels on the 
refrigerator.
Create custom door overlay panels according to the 
specifications in the Custom Panels and Handles section.
Dacor is not responsible for customer installed molding or 
decorative panels that need to be removed or replaced to
service the refrigerator.
Handle Installation
Before installing a custom panel assembly, install the custom
handle hardware.
Counter-sink the screw head into the back of the panel to allow
the panel to slide into place smoothly and for proper fit.
Door Panel Installation
Remove all tape and door bracing from the refrigerator and 1.
freezer doors.
Open the refrigerator and freezer compartment doors.2.
Installation Instructions
Custom Panel and Handle Installation - IF42/IF48 Series Models
A. Countersunk screw
Side View
B. Handle
C. Door panel assembly
B
A
C
Front View
Remove the handle side and top trims.3.
Slide the custom panels into the bottom and hinge side trims 4.
on the refrigerator compartment and freezer compartment
doors, making sure that the backer panel fits into the hinge
side trims.
Reinstall the handle-side and top trims.5.
Remove the protective skin from the screw covers. Slide or 6.
snap the screw covers into the handle trim section.
Check refrigerator level and alignment. Adjust if needed.7.
A. Trims
A
A
B. Panels
BB