Specifications

3. Raisethedoorsothatit isata 15° anglefromthefront
of theoven.Holdthedoorwithonehandoneachside.
Liftthedoorupandout.
i i
Door Gripping
Points
Install the Oven in the Cabinet
[_ WARNING
• Use an appliance dolly to move the appliance when
installing it or removing it from the wall for service. Use
of an appliance dolly will minimize the risk of personal
injury as a result of the oven tipping.
• Failure to install the mounting screws may result in
movement or tipping of the oven during use, or per-
sonal injury.
Do not block the oven air exhaust and intake located
at the bottom of the oven door(s). Blocking the airflow
may cause cabinet damage and poor baking perfor-
mance.
IMPORTANT
An Oven that is n0t !evel may Provide POOrOr inconsistent
baking results: J
1. Lift the oven up to the cabinet cutout using the handles
and gripping points shown. Use extreme caution when
lifting the appliance, because it is heavy.
jz \
Trim post
Gripping points
Handle
Trim post
Gripping point
,
,
,
Support the oven at all times until it is secured into the
cabinet. Be certain to take all necessary safety precau-
tions.
Resting the oven on the cabinet support platform, slide
the oven into the recessed area until the rear edge of
the oven trim post is flush with the cabinet face and
the oven is centered within the cutout. Ensure that
the electrical conduit slides through the opening in the
cabinet platform or coils above the oven chassis as the
oven is slid into place. Do not trap the appliance cable
between the oven case back and the rear wall.
Make sure the oven is resting level. Shim it if neces-
sary.
[_ WARNING
When installing the mounting screws into composite
cabinets; install them into the sides of the cabinet only;
Maunt!ng ScreWS installed into the front Of composite
cabinets will have a tendency to pull loose:
5. Find the mounting hole locations in the front and side
of the oven trim posts. Drill 1/16" pilot holes in the cabinet
through the front or side of the trim posts. Single oven
models require four (4) holes, while double oven models
require six (6).
6. Install the #6 x 3/4" screws provided in the instructions
envelope. Do not over-tighten.
©
DDODOD _
© ©
I_ o 11
4_
dacDr, 13