Installation Instructions Discover y ™ Wall Oven EO, MOH and MOV Series Part No. 65433 Rev.
All specifications are subject to change without notice. Dacor ® assumes no liability for changes to specifications. © 2007 Dacor, all rights reserved.
Table of Contents Before You Begin............................................................... 1 Important Safety Instructions........................................... 1 Important Information About Safety Instructions............... 1 Safety Symbols and Labels.............................................. 1 General Safety Precautions.............................................. 2 Customer Service Information.......................................... 3 If You Need Help..................................
Important Safety Instructions General Safety Precautions To reduce the risk of fire, electric shock, serious injury or death when using your appliance, follow basic safety precautions, including the following: WARNING • Read the accompanying use and care manual before operating this appliance. • • • WARNING • Keep packaging materials away from children. Plastic sheets and bags can cause suffocation.
Customer Service Information If You Need Help... Model Identification If you have questions or problems with installation, contact your Dacor dealer or the Dacor Customer Service Team. For repairs to Dacor appliances under warranty call the Dacor Distinctive Service line. Whenever you call, have the model and serial number of the appliance ready. The model and serial number are printed on the product data plate.
Product Specifications Product Dimensions All tolerances: ±1/16 (±1.6 mm), unless otherwise stated. Model Number A EO127 B 27” (68.6 cm) MOH127 MOV127 EO130 MOV130 EO227 MOV227 EO230 MOV230 K L 9/16” (1.4 cm) 1” (2.5 cm) 1 7/8” (4.6 cm) ® F MOH/MOV - Millennia 3 11/16” (9.4 cm) G H 7 3/8” (18.7 cm) 6 3/8” (16.2 cm) 50 1/2” (128.3 cm) J EO - Epicure 2 5/16” (5.9 cm) 51 1/16” (129.7 cm) 30” (76.2 cm) MOH230 E 27 3/8” (69.5 cm) 23 3/8” (59.4 cm) 27” (68.
Product Specifications Top of chassis C H E 1 1/4” (3.2 cm) D F G B Utility cutout Control panel front L J K Chassis notch side view 66” (167.6 cm) Flexible conduit A Top of chassis Single Wall Oven Dimensions Top of chassis C H E 1 1/4” (3.2 cm) D F Utility cutout B Control panel front Chassis notch side view L J K Top of chassis A G 66” (167.
Planning the Installation Selecting the Location • • Carefully check the location where the oven is to be installed. The oven should be placed for convenient access, but away from drafts that may be caused by doors, windows, and heating, ventilation and air conditioning outlets. Make certain that electrical power can be provided in the selected location. Be certain that proper clearance is provided for the oven door when it is in the open position.
Planning the Installation NOTES: D Recommended electrical location 1“ (2.5 cm) min. to bottom of door Recommended electrical location • Cutout tolerances: +1/16 (1.6 mm), -0, unless otherwise stated. • 24” minimum cutout depth. • 3/4” support platform must be flush with front of cutout. See page 8. 4“ (10.2 cm) min. between cutouts A 1 ¾“ (4.5 cm) min. clear to top of door for heat exhaust Duel Single Wall Oven Cutout A B B 3/4” (1.9 cm) support platform 3/4” (1.
Planning the Installation Cabinet Cutout (Continued) Support Platform warning The top surface of the support platform must be installed flush with the cutout in the front of the cabinet or wall and any trim. Failure to install the platform properly may cause the exhaust vent to deform and/or become obstructed. An obstructed exhaust area may cause the oven to malfunction. See below. Provide a platform within the cabinet to support the oven. A properly supported piece of 3/4” (1.
Planning the Installation Electrical Specifications important • Preheat times and cavity temperature recovery times will be increased slightly if operating on less than a 240 Vac circuit. • This appliance is provided with electrical connection leads in a flexible metal conduit.
Installation Instructions Electrical Service Installation warning • Wire the oven only in compliance with local ordinances. • If the electrical service provided does not meet the product specifications, do not proceed with the installation. Call a licensed electrician to install the required wiring. • To prevent an electric shock or fire hazard, turn off power to the circuit at the circuit breaker or fuse box prior to connecting the wiring to the oven. 1.
Installation Instructions Connecting to a Three (3) Wire Electrical System - Where Local Codes Permit warning Do not connect the green appliance conduit wire to the neutral (white) junction box wire unless local building codes permit. 1. Separate the wires coming out of the appliance conduit. 2. Connect the green and white wires from the appliance conduit to the white (neutral) supply wire in the junction box. 3.
Installation Instructions Connecting to a Three (3) Wire Electrical System with External Ground - Where Local Codes Permit (Continued) Cable from circuit breaker panel or fuse box Separate No. 10 min. copper grounding wire Wire nut (4 places) Junction box RED RED WHITE WHITE GREEN GREEN BLACK BLACK Clamp must be tight on pipe Conduit to wall oven Three (3) Wire Connection with External Ground Final Installation warning • A minimum of two people are required to safely install this appliance.
Installation Instructions 3. Raise the door so that it is at a 15° angle from the front of the oven. Hold the door with one hand on each side. Lift the door up and out. 2. Support the oven at all times until it is secured into the cabinet. Be certain to take all necessary safety precautions. 3. Resting the oven on the cabinet support platform, slide the oven into the recessed area until the rear edge of the oven trim post is flush with the cabinet face and the oven is centered within the cutout.
Installation Instructions Install Exhaust Deflector caution Install the exhaust deflector before installing the oven door(s). Attach the exhaust deflector to the front of the oven. It attaches to the oven just below the oven chamber in the door jam. On a double oven, the exhaust deflector is mounted below the bottom oven chamber. 1. Line up the mounting holes on the exhaust deflector with the screw holes on the front of the oven. 2. Secure it using the three (3) screws provided. 1.
Installation Instructions Lower lip of hinge receptacle Notch on bottom of hinge Door Installation Installation Checklist warning □□ Plastic coating, if applicable, has been removed from outside of oven. □□ All packaging materials have been removed from inside the oven. • To ensure a safe and proper installation, the following checklist should be completed by the installer to ensure that no part of the installation has been overlooked. □□ Power is turned on at circuit breaker or fuse box.
Notes 16
Dacor ● 14425 Clark Avenue, City of Industry, CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.