Technical information

Technical Manual - Page 31
ERC Quick Test
The process requires two people. To access the program, one person should stand at the oven,
while the other is located at the circuit breaker. The person at the circuit breaker turns off the
breaker and then the person at the oven depresses and holds the cooktime keypad. The person
at the circuit breaker then turns the breaker back on. The display will show the 4-character
identifi cation code of the ERC. Example (1180)
You have 30 seconds between each test mode.
Note: if unit shows time of day start procedure over again.
Test 1
Push and hold convection bake
Bake element and convection fan activate.
Test 2
Push and hold Standard Bake
Bake element activate.
Test 3
Push and hold Pure Convection
Convection fan and convection element activate.
Test 4
Push and hold broil
Broil element activate. (on gas units - ignitor will activate.)
Test 5
Push and hold convection broil (select models)
Broil element and convection fan activate.
Test 6
Momentary push timer 2
Audible tone will sound.
Test 7
Push and hold stop time
Cooling fan activate.
Test 8
Momentary push clock
All LEDs will light up. Push + or - key pad. LEDs wil display numbers
Example: 1111, 2222, 3333, 4444 etc.
Test 9
Last test door open, push and hold cook time for 10 seconds
Self clean latch motor activate. Door latch will complete one cycle.
The test will end and ERC will display the time of day.
NOTE:
Complete all tests within 30 seconds - otherwise you will see a failure code (F-0: Stuck key pad)
displayed on the ERC.