Installation Renaissance Models: Part No. 102579 Rev.
All specifications are subject to change without notice. Dacor ®assumes no liability for changes to specifications. © 2007 Dacor, all rights reserved.
Before You Begin .............................................................. Important Safety Instructions .......................................... Important Information About Safety Instructions .............. Safety Symbols and Labels ............................................. General Safety Precautions ............................................. Customer Service Information ......................................... If You Need Help ..............................................................
General Safety Precautions To reduce the risk of fire, electric shock, serious injury or death when using your appliance, follow basic safety precautions, including the following: [_ WARNING • Read the accompanying use and care manual • before operating this appliance. Keep packaging materials away from children. Plastic sheets and bags can cause suffocation. • If you receive a damaged product, immediately contact your dealer or builder. Do not install or use a damaged appliance.
If You Need Help... Model Identification If you have questions or problems with installation, contact your Dacor dealer or the Dacor Customer Service Team. For repairs to Dacor appliances under warranty call the Dacor Distinctive Service line. Whenever you call, have the model and serial number of the appliance ready. The model and serial number are printed on the appliance data plate. Dacor Customer Service EORS227SCH TTTTT A [] Web site: www.Dacor.
Power Supply Requirements It is the owner's responsibility to ensure that a licensed electrician performs the installation of the electrical supply for this appliance. The electrical installation, including minimum supply wire size, must comply with the National Electric Code ANSI/NFPA 70 (latest revision) and local codes and ordinances. A copy of this standard may be obtained • • • • from: Model Number 240 Vac 60 Hz, 4 wire*, 30 Amp. 5.0 kW (21 Amp.
Product Dimensions All tolerances: +1/16 (+1.6 mm), unless otherwise stated. Top of chassis Top of chassis C C D A Conduit: Control panel front I"1 / _[--i 60" (152 cm) Long \ _ _T°P \ I FI-_/-- of chassis A Chassis Notch Side View Single Conduit: /%-"x Oven Control panel I 14-_1 I _ . 60" (152 cm) Long ,ron,oh' (2.5 cm) (2.5 cm) Chassis Notch Side View _ Double Oven / 3 3/8"---,-V (8.
Dacor recommends installing the electrical junction box in the one of the locations shown. Installation Planning WARNING I " without being disconnected. observe all governing codes and OrdinanCes during plum I ning and instal!ationl C0ntact your local building depart_. ment for further information. ............. Plan the installation so that all minimum clearances are met or exceeded. Dimensions shown provide minimum clearances, unless otherwise noted.
Cabinet Dimensions Cabinet tolerances: +1/16 (1.6 mm),-0, unless otherwise stated. N N Recommended Recommended electrical location electrical location 1" (2.5 cm) Min. to bottom of cabinet door 1" (2.5 cm) min. to bottom of cabinet door • • \ II t' t "'m I I I I I I 3/4" (1.9 cm) R / support I i i I ; i I i i I i i )latform I- I -/-. I It 1" (2.5 cm) Min. to top of cabinet door Alternate electrical location 4" typical toe kick 3/4" (1.9 support m) form R P 1" (2.5 cm) Min.
Verify the Package Contents Verify that all the components below have been provided. If any item is missing or damaged, please contact your dealer immediately. Do not install a damaged or incomplete appliance. Make sure that you have everything necessary to ensure proper installation before proceeding.
Removing the Oven Door on Model EORS136: , 1. Open the door to its fully opened position. 2. Rotate the catch over the retaining arm on each hinge. , Lift the oven door to about a 15° angle from the vertical position. Hold the door with both hands just below the handle and pull it away from the oven while continuing to lift.
Electrical Connection-(continued) Connecting to a Four Wire Electrical Connecting System 1. , , , , to a Three Wire Electrical System-Where Local Codes Permit Separate the wires coming out of the appliance conduit. WARNING I Connect the white wire from the appliance conduit to the white (neutral) supply wire in the junction box. Donot connect thegreen app,ance conduit wire the Connect the black wire from the appliance conduit to the black (L1) supply wire in the junction box.
Connecting to a Three Wire Electrical System with External Ground - Where Local Codes Permit 4 AWG wire (minimum) \ WARNING • Do not ground the appliance to a gas supply pipe or hot water pipe. • If connecting the ground wire to a grounded cold water pipe, connect using a separate copper grounding wire (No. 10 minimum) and a clamp with an external grounding screw. The grounded cold water pipe must have metal continuity to electrical ground and must not be interrupted by insulating materials.
Installing the Oven in the Cabinet [_ • WARNING Failure to properly install the mounting screws may result in movement or tipping of the oven during use resulting in personal injury. • Do not blockthe oven air exhaust located at the bottom of the oven. Blocking the intake may result in a fire hazard, cabinet damage or poor performance. • The wall oven is heavy. Do not attempt to install it in the cabinet with less than two people.
Installing the Exhaust Grill With the oven secured to the cabinet, install the exhaust grill by mounting it to the oven with the two (2) provided screws. Reinstalling the Oven Doors [_ WARNING Failure to fully rotate the hinge Catches will result in a safety hazard and may cause persona! injurY due to the door falling off its hinges. Also damage to the oven and!or improper door alignment may occur.
Reinstalling the Oven Door (Cont) Verifying Proper Operation To re-install the oven door on model EORS136: WARNING To avoid personal injury or damage to the door from it falling off its hinges: • Make sure that the notch on the bottom of each hinge rests on top of the lower lip of each hinge receptacle before attempting to open the oven door. • Rotate the hinge locks toward the front of the range immediately after installation of the door. 1.
Installation Checklist WARNING To ensure proper installation;the installer must complete the checklist below to make sure that no part 0f the installation has been overlooked: .................................... [] Is the oven mount on a level platform? [] Is the oven wired and grounded according to these instructions and in accordance with all applicable electrical codes? See pages 4 and 9 through 11.
16 c_mcar
4# The Life of the Kitchen? Dacor • 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 • Phone: (800) 793-0093 • Fax: (626)403-3130 American Made*Family • www.Dacor.