Installation guide

Removing the Oven Door on Model
EORS136:
1. Open the door to its fully opened position.
2. Rotate the catch over the retaining arm on each hinge.
Catch
Retai 'n0
Steps 1 and 2
,
,
Lift the oven door to about a 15° angle from the vertical
position.
Hold the door with both hands just below the handle
and pull it away from the oven while continuing to lift.
Gripping
point
Gripping
point
Steps 3 and 4
Electrical Connection
WARNING
• If the electrical service provided does not meet the
Product Specifications (see page 4), do not proceed
with the installation. Call a licensed electrician to cor-
rectly install the required wiring.
• Failure to disconnect power prior to installation may
result in an electrical shock or fire hazard.
• Do not turn on power to the appliance until the oven is
properly grounded according to these instructions.
The installer must connect the ground terminal (or
lead) on the appliance to a grounded, metallic, perma-
nent wiring system or grounding conductor. Failure to
do so may result in an electric shock hazard.
• Do not use an extension cord with this appliance. Such
use may result in fire, electric shock or personal injury.
• Do not install a fuse in the neutral or ground circuit. A
fuse in the neutral or ground circuit may result in an
electric shock hazard.
• The appliance must be connected to the power supply
with copper wire only. The use of aluminum wire may
result in unsatisfactory conditions.
I @ IMPORTANT I
Provide slack in the conduit t0 all0w the 0Yen t0 slide f0ri I
ward for servicing. I
NOTE
The electrical connection leads from the supp!ied app!i-
ance condui t mayb e a smaller gage than the standa
household wiring ofth e dedicated Supply circuit- They
are suitable for connectio n to household wiring under the
jUrisdictio n of the a ati 0naI Electric Code •a nd!or the !oca!
inspection authority.
1. Before proceeding, turn off power to the circuit to which
the oven will be connected at the circuit breaker or fuse
box.
2. Position the oven directly in front of the cabinet cut out.
3. Feed the appliance conduit into the electrical junction
box and attach it using a UL approved strain relief.
4. Depending upon local codes, utilize one of three meth-
ods to connect the appliance to the electrical power:
¢ Connect to a four wire electrical system
¢ Connect to a three wire electrical system, where
local codes permit
¢ Connect to a three wire electrical system with
external ground, according to local codes.
See the instructions on the following pages for detailed
directions.
_mCD_ 9