Product specifications

4
Planning the Installation
Both the gas supply piping and shut-off valve, and the •
electrical junction box/receptacle must be located so they do
not interfere with the range when it is installed. In addition,
the junction box must be located so the range can be
removed for service when the conduit supplied with the unit
is attached to the junction box. Do not lengthen the conduit or
wiring provided with the range.
All dimensions shown are based on standard American •
cabinets 36 inches (914mm) high at the finished countertop
by 24 inches (610mm) deep, with a 25 inch (635mm) overall
countertop depth. All minimum clearances shown MUST be
maintained.
Carefully check the location where the range is to be •
installed. For best performance, the range should be placed
away from drafts that may be caused by doors, windows and
HVAC outlets.
If cabinet storage space is to be provided directly above the •
range, the risk of personal injury may be reduced by installing
a ventilating hood that projects horizontally a minimum of 5
inches beyond the face of the cabinets.
The range may be installed flush to the rear wall. Dacor •
highly recommends installing a non-combustible material on
the rear wall above the range and up to the vent hood. It is
not necessary to install non-combustible materials behind the
range below the countertop height.
WARNING
IMPORTANT: Observe all governing codes and ordinances
during planning and installation. Contact your local building
department for further information.
Cabinet and Countertop Preparation
The shaded areas shown in the illustrations below show the •
recommended location of the gas stub and the electrical
junction box/receptacle in the lower left corner of the adjacent
right cabinet. For replacement purposes, the location of the
existing utilities may be utilized provided that they do not
interfere with the sides or rear of the range. If installing the
gas valve behind the range, verify that doing so is permitted
by local building codes.
A manual shut valve must be installed in the gas piping, •
external to the appliance, for the purpose of turning on or
shutting off gas to the appliance. Plan the location of the
range and the gas supply to allow access to the valve when
the unit is installed. Access to the remote circuit breaker
panel/fuse box with the range in place must also be allowed
for in the installation. Any openings in the wall behind the
appliance and in the floor under the appliance must be
sealed.
**
** Cabinet depth is at discretion of customer
but cabinet face MUST NOT protrude further
than rear of front panel, see product dimesions
* Vertical to combustible surface
B
A
Non-Combustible
surface along
back wall
Suggested
location of
utilities
30” (762mm)
min.*
Model
Number
“A” “B”
ERD30
30 1/16”
(764mm)
36” (914mm)
Recommended
30” (762mm) Minimum
EGR30
ERD60
60 1/8”
(1572mm)
66” (1676mm)
Recommended
60” (1542mm) Minimum
Cutout Dimensions