Troubleshooting guide

Page 9-14
DACOR RANGE SERVICE MANUAL
Cooktop Component Repair (continued)
Knob Lights (LED assembly)
Turn off the gas supply and power to the
range at the junction or fuse box.
Remove the spill trays. See the Removing the
Spill Trays section on page 8-7.
Pull off the knob in front of the LED assembly
to be removed. Doing so will make it easier to
see the LED assembly from the back side.
The LED is held in place by the LED holder A
above the valve stem B .
T
o remove the LED, push in on the LED gently
with your finger. Then reach in from the back
side of the cooktop front panel C and pull
back on the wires connecting to the LED
.
•
•
•
•
A
B
C
C
E
D
Disconnect the LED assembly D at the
connector E about six (6) inches from the
LED
.
When remounting the LED, push the LED into
the LED holder from the back side until it
stops.
Replace the knob.
Reassemble the cooktop and test it to make
sure the LED is working and that the cooktop
has been reassembled properly.
•
•
•
•
Igniter Module
Turn off the gas supply and power to the
range at the junction or fuse box.
Remove the spill trays. See the Removing the
Spill Trays section on page 8-7.
Determine the igniter to be replaced by
tracing the igniter wire G from the burner
that is not sparking back to the module H
. The igniter modules are located under the
igniter module insulation I .
Disconnect the igniter wire and power supply
wires J from the module.
R
emove the screws that hold the module to
the chassis.
Install the new module, reconnect the wire
and replace the insulation.
Reassemble the cooktop and test it to make
sure that it has been reassembled properly.
•
•
•
•
•
•
•
H
G
I
J