Troubleshooting guide

Page 9-31
SECTION 9 - COMPONENT REPAIR
Turn off the gas supply at the supply valve
and power to the range at the junction or fuse
box.
Remove the spill trays as described starting
on page 8-7.
Remove the relay board cover G on the floor
of the cooktop chassis.
•
•
•
Oven Component Repair (continued)
Power Board and Lighting Transformer
G
I
H
The power board H and the lighting
transformer I are mounted to the chassis
inside the rela
y board cover.
Label and disconnect any wires that are
disconnected from the power board or
transformer before repair or replacement.
Reassemble the range in the reverse order
and test the oven to ensure that repairs were
properly completed.
•
•
•
CAUTION
The printed circuit board assemblies in this range contain electronic components that are
sensitive to electrostatic discharge (ESD). Wear a properly grounded antistatic wrist strap when
handling or servicing the printed circuit assemblies. Insert the ESD sensitive circuit boards into
antistatic bags before placing them on any surface other than the oven chassis.
•