Specifications

Final Installation
1. Peel the protective plastic coating off of the range, including
the range door.
2. Carefully slide the range into position in the cutout. The rear
anti-tip leg should engage the anti-tip bracket.
3. On self-rimming installations, reach under the range and
adjust the legs, lowering the range until the trim just makes
contact with the countertop on all three sides.
4. Use a level to make sure that the range does not tilt front to
back or side to side. Readjust the legs if necessary.
Re-installing the Oven Door
Installing the Burner Knobs
There are two (2) different types of knobs supplied with the range.
The knobs for the right burners have the words "MAX GRIDDLE"
on them.
NOTE: When installing the knobs, align the "D-shaped" opening
on the back of the knob with the end of the valve shaft. Carefully
push the knob on until it stops.
• Put the knobs with the words "MAX GRIDDLE" on them onto
the right valve shafts.
• Put the remaining knobs on the left valve shafts.
1. Grasp the oven door on opposite sides and hold it at a 15 °
angle from the front of the oven. Slide the hinges into the
hinge openings, resting the bottom of the hinge arms on the
hinge receptacles. Continue to hold the door at a 15° angle
with one hand while pushing in on each of the bottom corners
of the door. Push until the notch on the bottom of each hinge
slips over the lower tip of each hinge receptacle.
2. Lower the door to the fully opened position.
3. Rotate the two hinge locks toward the oven.
4. Slowly and carefully open and close the door completely to
ensure that it is properly installed.
5. Remove any packaging from inside the oven.
Icons on Left Burner Knobs
Icons on Right Burner Knobs
// : \
Notch on bottom _1 Lower tip
of hinge _ i_.j _ of hinge
J / receptacle
, --.,jj //
Door Installation
18 =::_acar