Product specifications

Page 6
Page 7
STEP 10
Removing the Oven Door
To remove door,
rotate catch up.
Lift door up to 30˚ angle,
then pull door away
from the range oven section.
30˚
Hinge Catch
Removing the Oven Door
Open the door to its fully opened position. Rotate the catch over the retaining arm on each hinge. Lift the oven door to about a 30 degree angle
from the horizontal position. Pull the door away from the oven while continuing to lift.
WARNINGS:
1. Do not attempt to disengage the hinge catches with the door removed from the oven. The hinge
springs could release causing personal injury.
2. Do not lift or carry the oven door by the door handle.
Grounding Instructions (ERD Models Only)
This appliance must be electrically grounded.
With the range positioned directly in front of the cabinet cutout, feed the appliance conduit to the electrical
junction box. Then, depending upon local codes, utilize one of the following techniques to connect the appliance to the electrical power
supply:
WARNINGS:
1. ERD models must be connected to a grounded, metallic, permanent wiring system. Alternatively,
a grounding conductor should be connected to the grounding terminal or lead on the appliance.
2. ERG models must be connected to a grounded receptacle. Failure to do so may result in an
electrical shock hazard.
3. Do not use an extension cord with this appliance. Such use may result in fire, electrical shock,
or other personal injury.
4. Do not install a fuse in the neutral or ground circuit. A fuse in the neutral or ground circuit may
result in an electrical shock hazard.
STEP 11
Electrical Connection
A. Connecting to a Four-Wire Electrical System (Refer to Figure 21 below)
1. Separate the green and white appliance wires.
2. Connect the white appliance wire to the neutral (white) supply wire in the junction box.
3. Connect the black appliance wire to the black (L1) power supply wire in the junction box.
4. Connect the red appliance wire to the red (L2) power supply wire in the junction box.
5. Connect the green appliance wire to the green house grounding wire in the junction box.
WARNING:
**Do not connect the green appliance wire to the neutral (white) supply wire unless local building
codes permit.
Conduit from
appliance
Cable from
po
wer supply
Wire nut
(4 places)
Junction
box
RED
RED
GREEN
GREEN
WHITE
WHITE
BLACK
BLACK
Conduit from
appliance
Cable from
power supply
Wire nut
(3 places)
Junction
box
RED
RED
GREEN
WHITE
WHITE
BLACK
BLACK
Connecting the appliance to a
four-wire power supply
**Connecting the appliance to a
three-wire power supply