Installation guide

Installation Instructions
Flectrical Installation 1. Run the wiring/conduit line used to supply power from
the raised vent to the blower parallel to the duct work.
WARNING 2. Make sure the raised vent power plug is disconnected
from the electrical outlet.
* ELECTRIC SHOCK HAZARD - Do not connect the
raised vent power plug-to the electrical outlet until 3. Remove the cover from the raised vent electrical
installation is complete. access panel.
+ Failure to complete electrical connections properly 4. Connect the wiring/conduit to the blower according to
may result in an electric shock hazard or a damaged the wiring diagrams on this page, the facing page and
or non-functional system. Follow the wiring diagrams local codes and ordinances. Make sure all terminal
carefully to ensure a proper installation. Do not connections, including the factory wired connections,
change the factory wired terminal. connections inside are tight.
re electrical access panel for.the-raised vent or the 5. Replace the electrical access panel.
ower.
« Jo-avoid an electric shock hazard and to prevent dam
age route-all-wiring away from-hot surfaces.
i
! Wires to power plug.
Match wire colors to Pre-wired at factory.
terminals as shown. Do not modify.
\
\ BLACK
Electrical access
Attach ground wire To power wiring/conduit.
as shown Connect other end of
wires to blower terminal
block.
Raised Vent Raised Vent
Front View Electrical Access Panel
10 cecor.