Installation Instructions PDF [1.75 MB]

8
Cut and remove the foil material inside the knock-out 2.
hole. If you fail to remove the foil, the vent will not work.
If the unit will vent through the bottom or side:3.
Attach the supplied ATD2 transition to exhaust •
location with the provided sheet metal screws.
For bottom installations cut a hole in the cabinet •
floor to allow the exhaust transition and/or the duct
to pass through the floor.
If the unit will exhaust air from the back, attach a 4.
3 1/4” X 10 duct to the vent hole created by removing
the knock-out on the back of the unit.
Installation Instructions
Back of unit
Side
knock-out
Side
knock-out
Bottom
knock-out
Rear knock-out with
metal cross overs
shown
Vent Knock-out Locations
ADT2 side
installation
ADT2 bottom
installation
Attach sealing
foam
ADT2 Transition Installation
Floor
Cut hole in floor to allow
duct to pass through on
bottom venting installations
Top of vent resting
on countertop
Installation Preparation
Verify Package Contents
Product literature•
Anchoring legs•
2 wood screws, #14 x 2 1/2 (PN 83047) •
3 wire nuts•
ADT2 duct transition•
2 sheet metal screws, #10 x 1/2 (PN 83022)•
2 keps nuts, 1/4-20 (PN 83049)•
2 flat washers, 1/4-20 (PN 83203) •
Insulation foam•
Installation
WARNING
If the electrical service (electrical outlet) does not •
meet the Electrical Specifications on page 4, do not
proceed with the installation. Call a licensed electri-
cian and have an electrical outlet installed that meets
the specifications.
Install the vent only in a vertical orientation. Do not •
mount the vent on a slant or angle.
NOTE: The raised vent installs in the back of the cutout,
separate from the range or cooktop. Install the raised vent
before installing the range or cooktop.
Installing the Raised Vent
Remove the appropriate side, back or bottom exhaust 1.
knockout, depending on the desired exhaust configura-
tion, from the raised vent chassis by cutting the metal
cross overs and removing the insert.