Planning Guide

All specications subject to change without notice.
Phone: [phone]www.dacor.com
PLANNING
GUIDE
4.21
4 1/4” (10.8 cm) min.
from mounting surface to
combustibles below
cooktop chassis
E
F
C
D
Minimum distance to combustible side
wall above countertop (both sides)
F
Vertical
combustible
surface
Rear
wall
1 5/8” min.
(4.1 cm)
Configuration C (Minimum) D E F (Minimum)
RNCT305G with no downdraft 3 1/4” (8.3 cm) 19 5/8” (49.9 cm)
27 5/8” (70.2 cm)
6 7/8” (17.5 cm)
RNCT305G with ERV3015 downdraft 3/8” (1.0 cm) 22 3/4” (57.8 cm)
RNCT365G with no downdraft 3 1/4” (8.3 cm) 19 5/8” (49.9 cm)
33 5/8” (85.4 cm)
RNCT365G with ERV3615 downdraft 3/8” (1.0 cm) 22 3/4” (57.8 cm)
For replacement purposes, a RNCT series cooktop will fit into the cutout of a Dacor SGM series cooktop.
Stiffener
Cabinet face
Countertop
Floor
3/8” min. (1.0 cm) space
behind downdraft vent
chassis to clear stiffener
3/8” min. (1.0 cm)
flat countertop overhang
required behind cutout
ERVxx15 downdraft vent.
Check downdraft vent
dimensions/specifications
to determine proper fit
DCT Series cooktop
Cabinet tolerances: +1/16” (+1.6 mm), -0, unless otherwise stated
Cutout Dimensions
SIDE VIEW - RNCT SERIES COOKTOP WITH DACOR DOWNDRAFT
Downdraft Compatibility
IMPORTANT: If installing cooktop with a
downdraft, install only the Dacor downdraft models
specified in the table below.
RNCT305G, RNCT365G
Renaissance
®
30” and 36” Wide
Drop-in Gas Cooktops
Document # PG04-011
Revised 07/06/16 Page 4/4
RNCTXXXG Series Cooktop