planning guide

ManualsBrandsDacor ManualsAppliancesDacor - Heritage 30" Gas Cooktop - Stainless steel

PLANNING

GUIDE

All specications subject to change without notice. www.dacor.com Ph. 800.793.0093

WARNING

• Observe all governing codes and ordinances during planning/

installation.

• Contact the local building department for details. This cooktop must

be installed as specified in its installation instructions.

Heritage

30”, 36” Dual Cooktop

Doc #: PGH-HDCT3036.01 Revised 29 Jan 2019 Page 1 of 5

All tolerances: ±¹/₁₆” (±1.6 mm) unless otherwise stated.

HDCT304, HDCT365

HDCT304

13/16”

(2.1 cm)

3 3/4”

(9.5 cm)

Gas inlet

Power cord

Chassis

Front of cooktop

Top panel overhang

2 1/8”

(5.4 cm)

5/8”

(1.6 cm)

HDCT304

Power Cord and Gas-Inlet Location

Summary of content (5 pages)

PAGE 1
HDCT304, HDCT365 Doc #: PGH-HDCT3036.01 Revised 29 Jan 2019 Page 1 of 5 All tolerances: ±¹/₁₆” (±1.6 mm) unless otherwise stated. Heritage® 30”, 36” Dual Cooktop PLANNING GUIDE WARNING • Observe all governing codes and ordinances during planning/ installation. • Contact the local building department for details. This cooktop must be installed as specified in its installation instructions. HDCT304 Front of cooktop Power cord Gas inlet 2 1/8” (5.4 cm) 5/8” (1.
PAGE 2
HDCT304, HDCT365 Page 2 of 5 All tolerances: ±¹/₁₆” (±1.6 mm) unless otherwise stated. Heritage® 30”, 36” Dual Cooktop PLANNING GUIDE HDCT365 Front of cooktop Gas inlet Power cord in 2 1/4” (5.7 cm) 1” (2.5 cm) HDCT365 Power Cord and Gas Inlet Location All specifications subject to change without notice. 1” (2.5 cm) 1 3/8” (3.5 cm) Chassis Top panel overhang www.dacor.com Ph. 800.793.
PAGE 3
HDCT304, HDCT365 Page 3 of 5 All tolerances: ±¹/₁₆” (±1.6 mm) unless otherwise stated. PLANNING GUIDE Heritage® 30”, 36” Dual Cooktop Electrical Requirements Gas-Supply Requirements WARNING To prevent electric shock, the power supply must meet the given specifications. The owner shall ensure that the electrical service meets requirements and that the power outlet is properly installed by a licensed electrician. • The cooktop has a 40-in.
PAGE 4
HDCT304, HDCT365 Page 4 of 5 All tolerances: ±¹/₁₆” (±1.6 mm) unless otherwise stated. PLANNING GUIDE Heritage® 30”, 36” Dual Cooktop Cabinet and Countertop Layout WARNING • To reduce risk of personal injury from reaching over a hot cooktop, avoid cabinet storage over the cooktop. • Failure to meet or exceed the maximum and minimum dimensions/ clearances as instructed may cause a fire hazard. • Follow the countertop manufacturer’s instructions regarding all aspects of countertop installation.
PAGE 5
HDCT304, HDCT365 Page 5 of 5 All tolerances: ±¹/₁₆” (±1.6 mm) unless otherwise stated. PLANNING GUIDE Heritage® 30”, 36” Dual Cooktop Countertop Cutout View Rear wall Vertical combustible surface 4 1/4" (10.8 cm) min. from mounting surface to combustibles below cooktop chassis F C E D F Min. distance to combustible side wall above countertop (both sides) 1 7/8" min. (4.8 cm) CUTOUT TYPE AND DIMENSIONS Installation Type (C) Minimum (D) HDCT304 (no downdraft) 2 7/8” (7.3 cm) 19 3/4” (50.