Installation Instructions Heritage Dual Cooktop HDCT304, HDCT365 Part No. 115027 Rev.
Table of Contents Important Safety Instructions.......................................1 Verifying Package Contents..........................................8 Important Information About Safety Instructions...........1 Installing the Cooktop....................................................8 General Safety Precautions..........................................1 Connecting the Gas Line..............................................8 Electrical Requirements................................................
Important Safety Instructions • The Important Safety Instructions and warnings in this manual cannot address all possible issues and conditions. Use common sense and caution when installing the cooktop. • Always contact Dacor Customer Assurance with questions and issues you cannot resolve. (See the contact info, facing page) Safety Symbols, Labels, and Alerts DANGER—IF YOU SMELL GAS: • do not use or light any appliance. • do not touch any electrical switch or use any electrical devices (incl.
Important Safety Instructions General Safety Precautions To reduce the risk of fire, electric shock, or serious injury or death when using your appliance, follow basic safety precautions, including the following: WARNING • Do not leave the cooktop unattended while in use to avoid the possibility of a fire. • Do not leave children alone or unattended in the area around the cooktop. Do not allow children to play with the controls or touch other parts of the cooktop.
Important Safety Instructions Electrical Requirements Gas Supply Requirements WARNING To prevent an electric shock hazard, the power supply must meet the specifications stated below. The owner shall ensure that the electrical service meets requirements and that the electrical outlet is properly installed by a licensed electrician. • A 40”, 3-prong, grounding power cord is connected to the the bottom-right rear corner of the chassis (see below).
Installation Specifications WARNING Observe all governing codes and ordinances during planning and installation. Contact your local building department for further information. Product Dimensions All tolerances: ±1/16” (±1.6 mm) unless otherwise noted. Model HDCT304 Front of cooktop Power cord Gas inlet 2 1/8” (5.4 cm) 5/8” (1.6 cm) 13/16” (2.1 cm) HDCT304 Power Cord and Gas-Inlet Location 3 3/4” (9.
Installation Specifications Product Dimensions (Con’t) All tolerances: ±1/16” (±1.6 mm) unless otherwise noted. Model HDCT365 Front of cooktop Gas inlet Power cord in 2 1/4” (5.7 cm) 1” (2.5 cm) 1” (2.5 cm) HDCT365 Power Cord and Gas Inlet Location 1 3/8” (3.
Installation Specifications Cabinet and Countertop Layout WARNING • To reduce risk of injury from reaching over a hot cooktop, avoid installing cabinets directly above the cooktop. • Failure to meet or exceed the given maximum and minimum dimensions/clearances may cause a fire hazard. • Follow the countertop manufacturer’s instructions regarding the minimum corner radius, use of heat reflective tape, reinforcement of corners, etc. • Carefully check the location where the cooktop will be installed.
Installation Specifications Cutout Dimensions All tolerances ±1/16” (±1.6 mm) unless otherwise noted. Countertop Cutout View Rear wall Vertical combustible surface 4 1/4" (10.8 cm) min. from mounting surface to combustibles below cooktop chassis F C E D F Min. distance to combustible side wall above countertop (both sides) 1 7/8" min. (4.8 cm) Countertop Cutout Dimensions Installation Type (C) Minimum (D) HDCT304 (no downdraft) 2 7/8” (7.3 cm) 19 3/4” (50.
Installation Instructions Verifying the Package Contents • Hold-down brackets (2) • Grates: HDCT304 (2), HDCT365 (3) • Burner sets: HDCT304 (4), HDCT365 (5) • Gas pressure regulator (1) • Stainless steel cleaner (1) (stainless steel models only) Connecting the Gas Line WARNING If any parts are missing, see Replacement Parts List on Pg. 12 for Dacor Customer Assurance and ordering information.
Installation Instructions Assembling the Burners WARNING • Never attempt to operate the cooktop with any of the burner parts removed. • Do not attempt to adjust the burner air mixture settings. All adjustments are preset at the factory. Remove the burner heads, burner rings, burner caps, and grates from their shipping packages. 1. 2. Place the caps on the burner assemblies as shown below to ensure proper function.
Installation Instructions Verifying Correct Setup Single-Burner Control Knob WARNING • Make sure that power to the electrical outlet is turned off at the circuit breaker panel or fuse box and that the gas is turned off at the gas supply valve before proceeding. • The cooktop must be properly grounded at all times when electrical power is applied. Before using the cooktop, read the User Manual carefully. 1. Turn off all the burner-control knobs. 2. Plug in the cooktop. 3.
Replacement Parts List Replacement Parts List Replacement parts can be obtained by contacting Dacor Customer Service. Grate Sizes Dacor Customer Assurance Phone: 833-35-ELITE (833-353-5483) USA, Canada) Mon – Fri 5:00 a.m. to 5:00 p.m.
Replacement Parts List Cooktop Parts Cooktop Layout LR RR LF RF Burner Location 12 LR Left Rear RR Right Rear CR Center Rear LF Left Front RF Right Front CF Center Front LR CR LF CF RR
Wiring Diagrams 120V, 60Hz. POWER SUPPLY VERIFY PROPER OPERATION AFTER SERVICING WIRING DIAGRAM HDCT304 DYCT304G HPCT304G CAUTION: LABEL ALL WIRES PRIOR TO DISCONNECTION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE IMPROPER AND DANGEROUS OPERATION.
Wiring Diagrams WIRING DIAGRAM WIRING DIAGRAM DYCT365G HPCT365G HDCT365 120V, 60Hz. POWER SUPPLY CAUTION: LABEL ALL WIRES PRIOR TO DISCONNECTION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE IMPROPER AND DANGEROUS OPERATION.
Notes
Dacor ● 14425 Clark Avenue, City of Industry, CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.
