Installation Instructions Professional® Gas Range Model HGR30P THIS APPLIANCE WAS TESTED ACCORDING TO THE LATEST EDITIONS OF ANSI Z21.1 AND CSA 1.1, STANDARDS FOR HOUSEHOLD-COOKING GAS APPLIANCES. Part No. 115279 Rev.
Table of Contents Important Safety Instructions...................................................................... 1 Consignes de Sécurité Importantes............................................................. 3 Planning the Installation............................................................................... 5 Electrical Requirements.................................................................................5 Gas-Supply Requirements...........................................................
Important Safety Instructions Important Info About Safety Instructions This manual cannot cover every possible problem and situation that can occur. Use common sense and caution when installing/maintaining/ operating this range. Always contact the Dacor Customer Service Team about problems and conditions that you do not understand. Safety Symbols and Labels These symbols and labels warn the following dangers: DANGER Immediate hazards that WILL cause severe injury or death.
Important Safety Instructions WARNING • Read the User Manual before operating the range. • Keep packaging away from children. Plastic sheets and bags can cause suffocation. • If you receive a damaged product, immediately contact your dealer or builder. Do not install/use a damaged appliance. • The range must be properly installed and grounded by a qualified installer as instructed in this manual before use.
Consignes de Sécurité Importantes Informations importantes sur les consignes de sécurité Ce manuel ne peut pas couvrir tous les problèmes et situations possibles. Faites preuve de bon sens et de prudence lors de l’installation/du maintien/de l’utilisation de cette cuisinière. Communiquez toujours avec l’équipe du service à la clientèle de Dacor au sujet des problèmes et des conditions que vous ne comprenez pas..
Consignes de Sécurité Importantes ATTENTION • Lisez le manuel d’utilisation ci-joint avant d’utiliser la cuisinière. • Gardez les matériaux d’emballage hors de la portée des enfants. Les draps et les sacs en plastique peuvent causer la suffocation. • Si vous recevez un produit endommagé, contactez immédiatement votre revendeur ou votre constructeur. Ne pas installer / utiliser un appareil endommagé.
Planning the Installation Electrical Requirements WARNING • Observe all codes and ordinances during planning and installation. Contact the local building department for details. • To prevent electric-shock hazard, the power supply must meet the specifications stated below. The owner shall ensure that the electrical service meets electrical requirements and that the outlet is properly installed by a licensed electrician.
Planning the Installation Product Dimensions Product tolerances: ±1/16” (±1.6 mm) Width: 29 7/8” (75.
Planning the Installation Cabinet Layout • For safe operation, maintain all specified maximum and minimum dimensions and clearances. • The range should be installed away from drafts (open doors/windows, home ventilation). • Do not install cabinets directly above the range, or reduce risk of fire and injury (from reaching over an active cooktop) by installing a range hood that projects horizontally at least 5” beyond the cabinet bottoms. • You may place the range against the rear wall.
Installation Instructions 1. Establish the range center line and front-panel locations via Product Preparing for Installation Dimensions (Pg. 5) and the cabinet/cutout dimensions. WARNING 2. Establish the anti-tip bracket location via the graphic on Pg. 9. With a pencil, mark the 4 mounting holes on the floor. If the home utilities do not meet product specifications, postpone installation. Call the dealer, the gas supplier, or a licensed electrician.
Installation Instructions Anti-tip bracket #8 x 1”, #8 x 1 1/4”, or #12 x 1 3/4 screw, 4 places (see text) Baseplate 1. Using the cabinet cutout dimensions and product dimensions on Pgs. 6 – 7, determine where the range centerline and front-panel locations will be once the range is installed. 2. Determine and mark the anti-tip bracket position (see diagram, left). 3. Place the bracket against the wall in the mounting location. 4. With a pencil, mark the wall at the bracket notches (both sides). 5.
Installation Instructions Removing the Oven Door WARNING • With the door off the range, do not remove the hinge catches. The springs could release abruptly, causing personal injury. • Do not lift/carry the oven door by the handle. So the range is easier to move, remove the door to reduce weight. 1. Open the door fully. 2. With needle-nose pliers and a flat-blade screwdriver, flip the catch out over each retaining arm. Catch Retaining arm 3.
Installation Instructions Final Installation Installing the Burner Knobs 1. Peel all protective plastic from the range. 2. Measure from floor to countertop, and adjust the leveling legs so the cooktop is even with the countertop. 3. On the bottom-rear of the range, turn the anti-tip foot until it is 1/16” (2 mm) off the floor. NOTE: Align the D-shaped opening on the back of the knob with the end of the valve shaft. Carefully push the knob on until it stops. Two types of knobs come with the range.
Installation Instructions Assembling the Cooktop WARNING Operate the cooktop only when all burners are properly assembled. 1. Remove the burner rings, burner caps, and grates from their shipping packages. 2. Install the burners as shown. When installing burner parts, twist each piece back and forth slightly until it drops into place. The burners do not work properly unless all pieces are properly seated. 3. Gently set the grates on the spill tray so each foot rests in its corresponding dimple.
Installation Instructions Verifying Proper Operation Moving the Range for Service Before operating the range, read the User Manual completely. It contains important safety, service, and warranty information. 1. Ensure that all control knobs are off and all burner components are properly assembled. 2. Open the gas-supply valve. 3. Plug in the range. The oven ON indicator blinks for 10 seconds on this initial startup. When the blinking stops, go to Step 4. 4.
Dacor ● 14425 Clark Avenue, City of Industry, CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.
