installation instructions
14
Installation Requirements
Location Requirements
Electrical Hookups (HIPR 30”, 36”)
Electrical Service Inlets
• Existing utilities may be used if they meet the spec's in this manual.
• The circuit-breaker panel/fuse box must be accessible without moving
the range.
• Junction box/receptacle must not impede placement of the range.
• Locate the junction box so the range can be pulled out for service with
-
out being disconnected.
ELECTRICAL-ACCESS DIMENSIONS
Model A B* C**
conduit bracket in bottom of electrical box.
Electrical Requirements
Follow these directions to reduce risk of property damage, personal injury, or death. The owner shall ensure
that the electrical service meets spec's and the electrical outlet is properly installed by a licensed electrician.
The correct voltage, frequency, and amperage must be supplied to the range from a separate, grounded,
• The wiring must be long enough that the range can be pulled out for service without being disconnected.
•
•
–
–
–
• Wiring to the range must include a strain
relief; must be terminated by tinned leads,
closed-loop terminals, or open-ended spade
lugs with upturned ends; and must connect
to a junction box or receptacle installed by a
licensed electrician.
Model Required Circuit Total Connected Load