Quick Start Guide

6
Cabinet Cutout Dimensions, cont. All tolerances: ±1/16 (±1.6 mm), unless otherwise stated
Countertop Flush-Cutout Dimensions—for
Down-Draft Vent (top view)
Width Dimensions (Inset Cutout)
Model A B
DYTT305 30 1/8” (76.5 cm) 28 3/4” (73.0 cm)
DYTT365 36 1/8” (91.8 cm) 34 3/4” (88.3 cm)
DYTT Cooktop w/Downdraft Cutout Dimensions
Model
Configuration
(C) Cooktop
Cutout Width
(D) Downdraft
Cutout Width
(E) Total
Cutout Width
(F) Downdraft
Cutout Depth
(G) Min. Rear
Counter Overhang
DYTT305 cooktop w/
ERV3015/PRV30
28 3/4” (73.0 cm) 27 3/4” (70.5 cm)
22 1/2” (57.2 cm) 2 3/4” (7.0 cm) 3/8” (1.0 cm)
DYTT365 cooktop w/
ERV3615/PRV36
34 3/4” (88.3 cm) 33 3/4” (85.7 cm)
DYTT305 cooktop w/
RV30 downdraft
28 3/4” (73.0 cm) 27 3/4” (70.5 cm)
22 1/4” (56.5 cm) 2 1/2” (6.4 cm) 5/8” (1.6 cm)
DYTT365 cooktop w/
RV36 downdraft
34 3/4” (88.3 cm) 33 3/4” (85.7 cm)
Countertop Inset-Cutout Dimensions
IMPORTANT (Inset Cutout)
See the previous page for minimum clearances to combustibles
and overhead cabinets.
IMPORTANT (Flush Cutout for Down-Draft Vent)
• See the previous page for minimum clearances to combus-
tibles and overhead cabinets.
• Install only the downdraft models in the DYTT Cooktop w/
Downdraft Cutout Dimensions table (below).
• If installing the cooktop with a downdraft flush with the
countertop, see the Countertop Inset-Cutout Dimensions
section (this page).
• The countertop inset for the downdraft must be lower to
accommodate the downdraft’s top cap, which extends the
height of the downdraft. (See the downdraft’s installation
instructions, available for download from www.dacor.com, to
determine the exact dimensions.)
• Sealing is also required between the cooktop chassis and the
downdraft due to the difference in required inset depth.
INSTALLATION SPECIFICATIONS