Planning Guide

PLANNING

GUIDE

All specications subject to change without notice. www.dacor.com Ph. 800.793.0093

Cabinet and Countertop Layout

WARNING

• To reduce risk of personal injury from reaching over a hot cooktop,

avoid cabinet storage over the cooktop.

• Failure to meet or exceed the maximum and minimum dimensions/

clearances as instructed may cause a fire hazard.

• Follow the countertop manufacturer’s instructions regarding all

aspects of countertop installation.

• Carefully check the cooktop installation site. Situate the

cooktop away from drafts and wet areas.

• Use the cooktop with a suitable vent hood or approved Dacor

downdraft.

Installation must allow:

• at least ” (6 mm) clearance between the bottom of the

cooktop chassis and all combustible surfaces, including the

edges and corners of drawers under the cooktop.

• clearance for hold-down brackets

• The gas supply piping, gas shut-off valve, and electrical outlet

must not interfere with the installed cooktop.

• If installing an appliance below the cooktop, allow for routing of

utilities behind it.

• access to the gas shut-off valve and regulator without moving

the cooktop.

• the 40” (101.6 cm) power cord to reach an electrical outlet, and

outlet to be accessable without moving the cooktop.

• access to the cooktop bottom for service/maintenance.(Do not

install fixed shelving below the cooktop.)

Downdraft Compatibility

If installing the cooktop with a downdraft, use only the approved

Dacor model numbers PRV46 or RV46. (See Pg. 4.)

Heritage

46” Wide

Drop-In Gas Cooktop

Page 3 of 4

All tolerances: ±¹/₁₆” (±1.6 mm) unless otherwise stated.

HPCT466G

Callout Description

1 Measured from top of cooktop grate

If installing with an overhead vent hood, also check hood

specifications for minimum required clearances.

Not applicable for cabinets more than a horizontal distance

of 6” (15.2 cm) from edge of cooktop; allow 7 ” (19.1 cm)

from edge of cutout.