installation instructions

10
Installation Instructions
SimmerSear Burner Assembly Standard Burner Assembly
Spill tray
Standard
burner
SimmerSear
burner
Burner cap
Burner cap
Burner ring
Burner ring
Burner head
Burner base
Burner base
Keyed hole
Ridge on bottom
of burner cap
Ridge on bottom
of burner cap
Burner Component Installation
WARNING
• Never attempt to operate the rangetop with any of the
burner parts removed.
• Do not attempt to adjust the burner air mixture set-
tings. All adjustments are preset at the factory.
• Remove the burner parts and grates from their shipping
packages.
• Install the burners as shown. Either type (color) of the
supplied burner caps may be used. When installing the
burner components, twist each piece back and forth
slightly until it drops completely into place. The burners
will not operate properly unless all of the burner pieces
are properly seated.
• Gently set the grates on top of the spill tray. Make sure
that the rubber feet are positioned in the dimples.
STEP 1: Install
burner head.
Put locating
tap into keyed
hole.
STEP 1: Put
burner ring on
top of the head.
STEP 3: Install
burner cap.
Ridge on cap
must surround
top of ring.
STEP 3: Install
burner cap. Ridge
on cap must sur-
round top of ring.
STEP 2: Install
burner ring. Line
up ring tabs
with head slots.
Twist back and
forth to assure
proper seating.
STEP 2: Turn
ring until it drops
into place. Twist
back and forth
to assure proper
seating.